2003 Sarena Bay™
Export Owner’s Manual
Warranty Service Information
Your hot tub warranty gives you specific coverage. Be sure to read the enclosed warranty sheet carefully.
The warranty does not cover problems arising from misuse, abuse, or neglect, and it does not cover problems caused by improper installation or “perceived” problems caused by failure to read the hot tub owner’s manual. A service charge will be made if a service call is made for any of the following:
1.Equipment failure due to improper/inadequate electrical service. All systems require dedicated circuits as described in this manual. Low voltage can cause equipment failure and seriously shorten equipment life. It is the owner’s responsibility to ensure proper electrical service is available.
2.Failure of hot tub to reach desired temperature because the set temperature is not turned up high enough. Maximum thermostat setting is approximately 40° C (≅104° F).
3.Burned out hot tub light. Bulbs are not covered.
4.Hot tub water chemistry is the responsibility of the hot tub owner. Cloudy, dirty or chemically unbalanced water and cleaning of the hot tub filter are also the responsibility of the hot tub owner.
5.Hot tub shell or equipment damage caused by improper water maintenance. Serious damage can be caused if your hot tub water is not maintained carefully and correctly.
6.Poor jet action because the jet Selector valve is in the middle position. For full performance, turn the jet Selector valve to either the full clockwise or full counterclockwise position.
Do not block air intakes located on the front left corner underneath the hot tub (the front right corner for the Chairman II and Triad II) and under the equipment access panel. Resulting malfunctions are not covered under warranty.
Warning
44