Dimension One Spas Sarena Bay manual JETS 1&2 Button, Jet Pump 3 Button, Feature

Page 28

JETS 1&2 Button

JETS 1&2 Button

2003 Sarena Bay™

Export Owner’s Manual

When the Jets 1&2 Button is pushed:

•The corresponding spa jet(s) pump is/are energized.

•The respective Status Indicator Light is illuminated,.

•The pump speed is indicated in the lower left corner of the Digital Display Window.

•A rotating swirl icon is displayed in the upper left corner of the Digital Display Window. The rotation speed of the swirl will vary according to the pump’s speed.

The first time the Jets 1&2 Button is pushed, pump 1 starts on LOW speed. When the same button is pushed again, the pump will change to HIGH speed. The third time the same button is pushed the pump will turn off.

Each time a Jets Button is pushed it activates a programmable, automatic shut- off cycle. The default time is 30 minutes. A progress bar, indicating the time remaining before the pump will turn off, is displayed immediately following the pump speed message. The pump automatic shut-off cycle is programmed separately. All pumps are controlled by the same automatically shut-off cycle.

Feature

The automatic shut-off cycles are a safety device that will reduce wear and tear on your equipment and reduce energy costs by ensuring that your pumps don’t run constantly.

Additionally, this feature allows for convenient filtration immediately after use of the hot tub by letting you “push the Jets Button” as you leave to get an additional 30/45/60 minutes of filtering.

Jet Pump 3 Button

When the Jets 3 Button is pushed:

•The corresponding spa jet pump is energized.

•The respective Status Indicator Light is illuminated,.

•The pump speed is indicated in the lower left corner of the Digital Display Window.

•A rotating swirl icon is displayed in the upper left corner of the Digital Display Window. The rotation speed of the swirl will vary according to the pump’s speed.

22

Image 28

Contents Page 2003 Sarena Bay Export Owner’s Manual Table of Contents PERSONAL THERAPY CONTROL PATENT PENDING SWITCHESHYDROSPORT AQUATIC FITNESS GEAR OPTIONAL Export Owner’s ManualUSING THE TOP SIDE CONTROLS ADJUSTING THE FOUNTAIN2003 Sarena Bay Export Owner’s ManualSPECIAL COLD WEATHER INSTRUCTIONS 2003 Sarena Bay Export Owner’s Manual Safety First IMPORTANT SAFETY INSTRUCTIONSREAD AND FOLLOW ALL INSTRUCTIONS CAREFULLY READ AND FOLLOW ALL INSTRUCTIONS CAREFULLYTo Reduce the Risk of Injury Hyperthermia Do’s and Don’ts Don’tDON’T block or sit on the filter recess area DON’T allow horseplay or unsupervised use of your Sarena BayWarning Signs Dimension One Spas 2611 Business Park Drive Vista, CA 760Sarena Bay Features Personal Therapy Control Patent Pending SwitchesDynamic LED Underwater Lighting FountainRevolutionary Design Features Innovative Seating - ForBioForm Recliners Bio-Wall / Bench SeatPivot feature “No-float” angles Upright position Multiple Lounges AccommodateBench Seat Pivot SeatFrontal Therapy Seat Sport Zone Seatjets the front part of the upper and lowerTop Side Control Additional Design FeaturesScrolling Message Center section PTC Switches Dynamic Massage SequencerFountain Synchronous Spa LightsHydroSport / OptiMounts Weir Basket / SkimmerSoft Tile Pillow NeckFlex Jet Pillow Jet System Selector ValveInfraRed Sensor Remotely Control The Sarena BayUltraPure Water Management System VisionSmart Heat Load SharingHydroSport Aquatic Fitness Gear Optional D1 Remote Control OptionalSonic Immersion System SIS Optional Initial Startup Weir Skimmer/Filter 2003 Sarena Bay Export Owner’s Manual 2003 Sarena Bay Export Owner’s Manual Operation Using The Top Side ControlsScrolling Message Center Jet Pump 3 Button JETS 1&2 ButtonFeature Water Feature Button Up / Down Buttons Light / Enter Button PROGRAM ButtonRinse Filters Clean Filters Heat Status Light Dimension One Spas ICON Logo→Scrolling Message Center Messages DO NOT ENTER THE WATER when “OVERHEAT” is displayed on Change Water Change Vision CartridgeSpa Check Up OverheatErroneous Temperature on the Display Ice Flashing Display and/or “Check Water Level”Cooling Programming the Scrolling Message Center Setting the TimeSummer Mode Standby Mode Filter Cycle Start Time Filter Cycle DurationNumber of Filter Cycles Pump Run TimeTemperature Unit Selection Vision CartridgeWaterfall Run Time Digital Display Window InvertProgramming Lock Control Panel ResetProgramming Unlock Dynamic Massage Sequencer Control Panel DescriptionLIGHT Button JETS ButtonSPEED Button BEGIN/PAUSE ButtonSEQUENCE Button Massage ZonesMassage Zone Description Zone AZone B Zone CZone F Operating the Dynamic Massage SequencerAdjusting Water Flow Adjusting the FountainJet System Selector Valve Standard VCR Jets→ - Directional Adjustable and Interchangeable JetsStandard VCR Jets→ - Rotator Mini VCR Jets→ - Rotator Mini VCR Jets→ - Directionala Mini VCR Jets→- Rotator Euro Jets - DirectionalFilter Cleaning Routine Equipment MaintenanceDraining Your Equipment Surface Care Light Bulb ReplacementUltralife→ Shell Dimension One “ EnviroTect” Skirts and Vinyl Covers Special Cold Weather InstructionsCare for the Wood Spa Cabinet Items Required for WinterizingProcedure for Winterizing Spring Time Startup Warranty Service Information Term Glossary of TermsDefinition Pump Troubleshooting Guide SymptomProblem Heating SystemElectrical System Cont Water System2003 Sarena Bay Export Owner’s Manual 2003 Sarena Bay Export Owner’s Manual