Dimension One Spas Sarena Bay Troubleshooting Guide, Heating System, Electrical System, Symptom

2003 Sarena Bay™

Export Owner’s Manual

Troubleshooting Guide

Heating System

	Symptom		Problem			Corrective Action
Does not heat			1.	Temperature setting is		1.	Turn up the thermostat
				too low
		2.		Dirty filter	2.		Clean filter
			3.	Flow switch malfunction		3.	Call for service
Too hot		1.		Temperature setting is to	1.		Turn down the thermostat
				high
			2.	High limit tripped		2.	Call for service
Erroneous		Possible temperature sensor			Call for service
temperature of		failure
0° C (≅32°F)or
57.8° C (≅136°F)
appears on the
display
Hot Tub			Water level			Fill with water to the bottom of the OptiMount™ located next to the
Temperature						Skimmer Basket.
erratic
Display reads		1.		Too much filtration	1.		Reduce the number of filter cycles and/or the filter cycle duration
OVERHEAT			2.	Temperature setting too		2.	Turn down the thermostat
				high
		3.		High limit or sensor	3.		Call for service
				problem

Electrical System

Symptom	Problem			Corrective Action
Will not turn on	No power		Check circuit breaker and/or GFCI
– in any mode
Turns on by itself	Normal automatic daily			No action required
	power filtration, or anti-
	freeze cycle
Light is out	Burned out bulb		Replace bulb
Pump shuts	1.	Automatic timer		1. Push JETS pad again to start another cycle
down		has shut pump off
unexpectedly	2.	Motor over-heated		2. If pump(s) will not restart when JETS pad is pushed, call for service
while in use
		and automatic
		protective device		Make sure that the equipment panel vent area is not blocked. Vent blockage
		has shut down		can cause serious damage to your equipment.
		pump(s)

47