Operation Notes
•Visually check the Chipper Knife for damage each time you use the machine.
NOTE: Check for shaft movement while starting the engine. If the shaft does not turn, clean out the Chipper as instructed on page 22.
•At engine
•Proper Rotor speed is
•When viewed from the Chipper Hopper side (Operator Zone, Figure 4), the Flywheel turns in a clockwise direction.
•Always wear protective gloves and safety glasses during operation of the DR 10 HP CHIPPER.
•If it becomes necessary to push material into the Chipper Hopper, only use a wood stick, NEVER your hands, or any foreign material such as plastic or metal.
•NEVER assume you know where the Chipper knife is. You do not know where it is. Always keep hands out of the Chipper Hopper.
•Keep area of discharge clear of people, animals, buildings, glass, or anything else that will obstruct clear discharge, cause injury, or damage. Wind can also change discharge direction, so be aware.
•ALWAYS operate the DR 10 HP CHIPPER from the Operator Zone (Figure 4).
•Keep proper balance and footing while operating the chipper.
•When feeding material into the Chipper Hopper, be extremely careful that pieces of metal, rocks, or other foreign objects are not included. Personal injury or damage to the machine could result.
•NEVER operate the machine without the Chipper Hopper and Discharge Chute properly installed.
•If the cutting knife strikes a foreign object or if your machine should start making an unusual noise or vibration, immediately stop the engine and wait five (5) minutes for all moving parts to come to a complete stop and cool. After the machine has come to a complete stop proceed as follows:
-Disconnect the spark plug wire.
-Inspect for any damage and repair or replace any damaged parts before restarting and operating the machine.
•ALWAYS stop the engine when leaving the Operating Zone (Figure 4) or when moving the Chipper.
Operator Zone
Engine | Top | Discharge |
| ||
| Area | |
|
| |
| Figure 4 |
|
18 DR® 10 HP CHIPPER