Country Home Products manual DR 10 HP Chipper

Page 8

ALWAYS turn OFF the engine, wait five (5) minutes to make certain the flywheel and all moving parts have come to a complete stop and cool and then disconnect the spark plug wire before opening this access panel. (#080-0970)

To avoid injury, keep your hands and feet out of the Inlet and Discharge Chutes. (#091-0055)

To avoid injury, never remove the protective cover while the flywheel is turning. (#091- 0059)

To avoid injury, keep your hands and feet out of the Inlet Chute. (#091-0088)

This label reminds you about the importance of reading and understanding the Safety & Operating Instructions manual and of paying attention to the safety warnings. (#091-0380)

To avoid injury, keep your hands and feet out of the Inlet and

Discharge Chutes. (#091-0057)

4 DR® 10 HP CHIPPER

Image 8

Contents DR→ 10 HP Chipper Safety & Operating Instructions Toll-free phone 1-800-DR-OWNER Table of Contents Iv DR 10 HP Chipper Introducing the DR 10 HP Chipper Conventions used in this manualDR 10 HP Chipper General Safety Rules LabelsDR 10 HP Chipper DR 10 HP Chipper is made in the U.S.A. #091-0062 Protecting Yourself and Those Around You Safety for Children and Pets Safety with Gasoline Powered EnginesGeneral Safety Additional Information and Potential Changes 10 DR 10 HP Chipper Setting UP Your DR 10 HP Chipper UnpackingRepresentatives at our toll free number 1-800-DR-OWNER Tools and Supplies NeededBe careful when cutting the banding Tool Needed Attaching the Chipper HopperCheck the Tire Pressure Adding the Engine Oil and Gasoline CapacitiesFront 16 DR 10 HP Chipper Operating Your DR 10 HP Chipper Before Starting the EngineOperation Notes Processing Limbs and Branches Starting and Stopping the Engine Using the Chipper Hopper Reassemble To Free a Jammed FlywheelDisassemble Call Toll Free 1-800-DR-OWNER 24 DR 10 HP Chipper Regular Maintenance Check List ProcedureMaintaining the DR 10 HP Chipper EveryGrease Fittings Supplies NeededRemoving and Replacing the Engine Oil Adjusting or Removing and Replacing the Drive Belt 2 WrenchEngine Bolts, Front Belt Tensioner Clutch Drive Belt Removing and Replacing the Chipper Knife Knife SharpeningTools Needed Adjusting the Knife to Wear Plate Gap Wrench or Socket Gap Gauge providedRemoving and Replacing the Clutch DR 10HP Chipper Engine at less than full RPMInstalling a New Clutch Assembly Clutch Removal, Disassembly, and Re-Assembly End of Season and Storage 38 DR 10 HP Chipper Troubleshooting Troubleshooting TableEngine smokes Flywheel will not turn Drive Belt burns Chipper Knife is hitting the Wear Plate Part# Description Parts LISTS, Schematic Diagrams and WarrantyParts List DR 10 HP Chipper Schematic DR 10 HP Chipper Parts List Chipper Assembly Not IllustratedSchematic Chipper Assembly 46 DR 10 HP Chipper DR 10WarrantyHP Chipper Daily Checklist for the DR 10 HP Chipper