Country Home Products 10 HP manual Call Toll Free 1-800-DR-OWNER

Page 27

3.Add a 5/16" Flat Washer to the end of the Bolt followed by a 5/16"-18 Lock Nut. Do not tighten at this time.

4.Repeat Steps 2 and 3 for the lower Deflector attachment Bolt.

5.Pull up on the end of the Deflector and tighten the two (2) Lock Nuts.

6.Reconnect the spark plug wire and start the Chipper engine; allowing the material in the Chipping Chamber to discharge.

7.If the Chipping Chamber does not clear and the flywheel is still jammed, repeat above process.

8.Be certain the Chipping Chamber is clear before trying to process more material into the Chipper Hopper.

CALL TOLL FREE 1-800-DR-OWNER

23

Image 27

Contents DR→ 10 HP Chipper Safety & Operating Instructions Toll-free phone 1-800-DR-OWNER Table of Contents Iv DR 10 HP Chipper Conventions used in this manual Introducing the DR 10 HP ChipperDR 10 HP Chipper Labels General Safety RulesDR 10 HP Chipper DR 10 HP Chipper is made in the U.S.A. #091-0062 Protecting Yourself and Those Around You Safety with Gasoline Powered Engines Safety for Children and PetsGeneral Safety Additional Information and Potential Changes 10 DR 10 HP Chipper Tools and Supplies Needed Setting UP Your DR 10 HP ChipperUnpacking Representatives at our toll free number 1-800-DR-OWNERBe careful when cutting the banding Attaching the Chipper Hopper Check the Tire PressureTool Needed Capacities Adding the Engine Oil and GasolineFront 16 DR 10 HP Chipper Before Starting the Engine Operating Your DR 10 HP ChipperOperation Notes Processing Limbs and Branches Starting and Stopping the Engine Using the Chipper Hopper To Free a Jammed Flywheel DisassembleReassemble Call Toll Free 1-800-DR-OWNER 24 DR 10 HP Chipper Every Regular Maintenance Check ListProcedure Maintaining the DR 10 HP ChipperSupplies Needed Grease FittingsRemoving and Replacing the Engine Oil 2 Wrench Adjusting or Removing and Replacing the Drive BeltEngine Bolts, Front Belt Tensioner Clutch Drive Belt Knife Sharpening Removing and Replacing the Chipper KnifeTools Needed Wrench or Socket Gap Gauge provided Adjusting the Knife to Wear Plate GapDR 10HP Chipper Engine at less than full RPM Removing and Replacing the ClutchInstalling a New Clutch Assembly Clutch Removal, Disassembly, and Re-Assembly End of Season and Storage 38 DR 10 HP Chipper Troubleshooting Table TroubleshootingEngine smokes Flywheel will not turn Drive Belt burns Chipper Knife is hitting the Wear Plate Parts LISTS, Schematic Diagrams and Warranty Parts List DR 10 HP ChipperPart# Description Schematic DR 10 HP Chipper Not Illustrated Parts List Chipper AssemblySchematic Chipper Assembly 46 DR 10 HP Chipper DR 10WarrantyHP Chipper Daily Checklist for the DR 10 HP Chipper