Country Home Products 10 HP manual Engine Bolts, Front Belt Tensioner Clutch

Page 33

NOTE: After you perform the adjustment, make sure that the Key remained in the Rotor Shaft and flush with the end surface of the Shaft (Figure 11 on page 30).

c)Apply Loctite® 243 to the threads of the Set Screws and reinsert them into the Drive Pulley Hub.

d)Tighten the Set Screws while maintaining the alignment of the Clutch and Rotor Pulley (Figure 11).

e)Recheck the alignment after tightening the Set Screws.

6. Reinstall the Belt Guard.

NOTE: Check and re-tighten the Drive Belt, if necessary, after an initial break-in period of one (1) hour.

Engine Bolts, Front

Belt Tensioner

Figure 9

Clutch

Rotor Pulley

Belt

Straight Edge

Figure 10

CALL TOLL FREE 1-800-DR-OWNER

29

Image 33

Contents DR→ 10 HP Chipper Safety & Operating Instructions Toll-free phone 1-800-DR-OWNER Table of Contents Iv DR 10 HP Chipper Conventions used in this manual Introducing the DR 10 HP ChipperDR 10 HP Chipper Labels General Safety RulesDR 10 HP Chipper DR 10 HP Chipper is made in the U.S.A. #091-0062 Protecting Yourself and Those Around You Safety with Gasoline Powered Engines Safety for Children and PetsGeneral Safety Additional Information and Potential Changes 10 DR 10 HP Chipper Unpacking Setting UP Your DR 10 HP ChipperRepresentatives at our toll free number 1-800-DR-OWNER Tools and Supplies NeededBe careful when cutting the banding Attaching the Chipper Hopper Check the Tire PressureTool Needed Capacities Adding the Engine Oil and GasolineFront 16 DR 10 HP Chipper Before Starting the Engine Operating Your DR 10 HP ChipperOperation Notes Processing Limbs and Branches Starting and Stopping the Engine Using the Chipper Hopper To Free a Jammed Flywheel DisassembleReassemble Call Toll Free 1-800-DR-OWNER 24 DR 10 HP Chipper Procedure Regular Maintenance Check ListMaintaining the DR 10 HP Chipper EverySupplies Needed Grease FittingsRemoving and Replacing the Engine Oil 2 Wrench Adjusting or Removing and Replacing the Drive BeltEngine Bolts, Front Belt Tensioner Clutch Drive Belt Knife Sharpening Removing and Replacing the Chipper KnifeTools Needed Wrench or Socket Gap Gauge provided Adjusting the Knife to Wear Plate GapDR 10HP Chipper Engine at less than full RPM Removing and Replacing the ClutchInstalling a New Clutch Assembly Clutch Removal, Disassembly, and Re-Assembly End of Season and Storage 38 DR 10 HP Chipper Troubleshooting Table TroubleshootingEngine smokes Flywheel will not turn Drive Belt burns Chipper Knife is hitting the Wear Plate Parts LISTS, Schematic Diagrams and Warranty Parts List DR 10 HP ChipperPart# Description Schematic DR 10 HP Chipper Not Illustrated Parts List Chipper AssemblySchematic Chipper Assembly 46 DR 10 HP Chipper DR 10WarrantyHP Chipper Daily Checklist for the DR 10 HP Chipper