TROUBLE SHOOTING
This is a
No display at topside
-check that the topside is correctly plugged into spa pack
-the power is on
-if problem persists contact Smart Protect Warranty
Display is flashing
A power failure must have occurred and the spa pack has returned to its default values. Press any key to stop the flashing and then reprogram the filter cycle.
Pump has started up for 1 minute on several occasions and “Filter” indicator is flashing
This is a feature of the SMART WINTER MODE.
It protects your spa from the cold by turning the pump on for 1 minute several times a day to prevent water from freezing in the pipes.
Water temperature is flashing
This indicates that the spa water temperature is over 112° F(44°C).
DO NOT enter the water! Remove spa cover and allow the water to cool down. The system will reset itself when the water temperature reaches 109°F(43°C)
Call Smart Protect Warranty if the problem persists.
Ground Fault Interrupter Trips
-Be sure that the neutral on the GFCI has been wired properly in the main panel.
-Check if it does it only when heat turns on, if so check element by removing the power to the element termi- nal and turn the heat on. If it only faults when the ele- ment is connected with power, the element has a ground fault and must be replaced.
-This can be done by unplugging the pump, ozonator, or any other peripheral equipment as a process of elim- ination to see where the fault may be.
18