Aruba Spa Hot Tub Models 2003 owner manual Tools Required for Installation

Page 5

TOOLS REQUIRED FOR INSTALLATION

•Voltmeter

•Ammeter

•Ohmmeter

•Screwdrivers (Phillips & flat head)

•2 wire restrainers

•Wire cutters

•Wire strippers

•#6 AWG 3 wire (plus ground)

ITEMS REQUIRED FOR THE

INSTALLATION OF YOUR SPA

•At least four people are required at time of delivery to place your spa into position.

•220 Volt Electrical Service

•An Electrician to do the electrical connection.

•50 Amp GFCI circuit breaker (included with your spa, see page 8)

•An Allen Key to open and remove the access panel. (sup- plied by Aruba Spas)

4

Image 5

Contents Aruba Spas Dear Aruba Customer IntroductionHOW Your Aruba SPA is Built Getting Started Items Required for Installation of Your SPA Tools Required for InstallationImportant Safety Instructions Special Cold Weather Start UP Preparations Positioning Your SPAIndoor Installation Deck Installation Yard InstallationElectrical Connection Electrical Connection AccessImportant Safety Instructions START-UP Preparations SPA Pack Only turn union one turn Counter clockwise Initial START-UPSPA Operations Guide Filter Cycle Programming Pump buttonLight or LED Setting Water Temperature Micro Directional Hydrotherapy JetsSwirl Jet Cluster JetsMassage Jet Trouble Shooting Problem has Been Detected Pressure SwitchJET Blower System OzonatorsAqua Pure Water System Circulation PumpAqua Pure Water System cont’d Chemical Maintenance Initial Start UP Procedures Weekly Water Maintenance ScheduleConducting Proper Water Tests Bromine Problems Associated with Improper Water Balance Chemical Table Equivalents ChartLow pH High pHDraining Your SPA Care for Your SPACauses of pH change To drain the spaSPA Surface Filter CleaningCover CabinetPage Special Cold Weather Instructions Warranty Information Warranty Page Problem Diagnosis Action Trouble Shooting GuideEye or skin irritation PH is too low Weekly Maintenance Schedule Division Leathead Road Kelowna, BC V1X 2J8