Setting Water Temperature

Using the heat up and heat down buttons, you can regulate the water temperature directly from the topside control pad. Press and hold the button to increase (or decrease ) current temperature setting. The temperature setting will be dis- played for 5 seconds to confirm your new selection. Water temperature can be adjusted by 1o increments from 40° to 104°F (15° to 40°C).

AIR CONTROLS

There are two air controls beside the topside control panel. By turning these controls you may adjust the amount of air going to the jets. When fully open you are getting the maxi- mum amount of air for full hydrotherapy action. To reduce the amount of air coming out of the jets simply close the air controls.

CELSIUS OR FAHRENHEIT

To change from one to the other, it is a matter of changing a jumper pin position on the board inside the spa pack. The #2 jumper location, on the board, is to the left of the topside plug. There are 2 positions for each jumper on 3 pins. If the jumper is placed on the left and middle pins, temperature readings will be in fahrenheit. If the jumper is placed on the middle and right pins the temperature readings will be in celsius.

SMART WINTER MODE

If your spa has gone into Smart Winter Mode the filter icon at the topside will flash. Smart Winter Mode will automati- cally start when the outside temperatures have dropped enough for the spa pack to reach 55° F. The pump will come on high speed for one (1) minute every two (2) hours to cir- culate the water. The Smart Winter Mode will run for 24 hours when activated. Smart Winter Modes will increase at the following temperatures at increased cycle times. See below:

55° - 1 minute every 2 hours 46° 1 minute every 1 hour 41° 1 minute every 30 minutes

37° and lower 1 minute every 15 minutes

These cycle times will continue for a 24 hour period mini- mum or until the breaker has been reset provided the ambi- ent heat inside the pack has surpassed 55°.

Note: if you have a circulation system the Smart Winter Mode will still activate when the ambient heat inside the pack has reached 55°.