Circulation Pump

OPTIONAL PURCHASE ON THE DELUXE ARUBA SPA

STANDARD OPTION ON THE EXECUTIVE ARUBA SPA

The circulation system is operated by a 1/15HP motor that draws about 1 amp. You can not operate the circulation sys- tem from the topside control as it is pre-programmed to run 24 hours a day. The circulation system efficiently circulates the spa water through the filtration system, as well as purg- ing water from the lines for one (1) minute every 12 hours on high speed of the main pump.

When you start up your spa ensure that both knife valves on either side of your circulation pump are in the open position (up). Loosen the union to release any air, then re-tighten. Ensure that the cord to the circulation pump is plugged into the spa pack tightly.

AQUA PURE WATER SYSTEM

OPTIONAL PURCHASE ON THE BASIC ARUBA SPA AND THE DELUXE ARUBA SPA

STANDARD OPTION ON THE EXECUTIVE ARUBA SPA

The Aqua Pure Water System is an automatic bromine gener- ator that is virtually maintenance free.

Sodium bromide is added to the spa water. Once it is dis- solved, it circulates through the plumbing to reach the elec- trodes which convert it to free bromine before reverting back to sodium bromide (it is a perpetual cycle). Additional sodi- um bromide is only added when the water level declines due to splash out, or when spa is drained/filled.

-Fill spa with water up to the water line

-Make sure the DECREASE/INCREASE dial on the face of the Aqua Pure Water System is turned to the OFF position.

-Balance your alkalinity

-Balance your pH

-Make sure that the spa’s pump is turned on to low or high speed

-Add 4 1/2 bottles of TRU BLU sodium bromide evenly over the surface of the water, shaking each bottle well first to break up any lumps