Ariens 911194 warranty Check Drive Belt, Check Fasteners, Check AIR Cleaner, Change Engine OIL

Page 19

3.Check mower blade balance.

Slide mower blade on an unthreaded bolt. A balanced blade should remain in a horizontal position. If either end of mower blade moves downward, sharpen the heavy end until blade is balanced (Figure 12).

4.Install mower blade on unit.

5.Tighten the bolts to a torque of 37.5 - 50 lbf-ft (51-68 N•m).

T

Blade

Bolt

OA0013

Figure 12

CHECK DRIVE BELT

(Self-Propelled Models)

Check drive belt and replace if worn or damaged. See DRIVE BELT REPLACEMENT on page 20.

CHECK FASTENERS

Check all fasteners for proper tightness. Pay special attention to blade hardware and all guards, shields and safety devices.

CHECK AIR CLEANER

See engine manual for specific information.

CHANGE ENGINE OIL

IMPORTANT: Change engine crankcase oil after first five (5) hours of operation. Then change oil after every 25 hours of operation.

Refer to engine manual for instructions and proper oil type.

IMPORTANT: Proper oil level must be maintained at all times or engine damage will result. DO NOT overfill. Be sure engine is level when adding oil.

GENERAL LUBRICATION

Swivel Wheels (911194)

See Figure 13.

Use Mix Hi-Temp Grease or equivalent on the lube fittings. Order P/N: 00036800 - 3 pack of 3 oz. cartridges.

Lube Fitting

OM1282

Figure 13

CHECK SPARK PLUG

Spark plug should be replaced every 100 hours of operation or each year.

NOTE: Loose spark plug wire terminals can cause sparking. Replace terminal if damaged.

CHECK ENGINE COOLING

WARNING: HOT SURFACES can cause death or serious injury. DO NOT TOUCH parts which are hot from operation. ALWAYS allow parts to cool.

To prevent overheating, air must circulate freely around the cooling fins, cylinder head and block.

Every 100 hours of operation or yearly (more often if conditions require) remove blower housing and clean cooling fins. See engine manual for instructions.

CHECK MUFFLER

Check muffler for debris, cracks, wear, or other damage.

CAUTION: Replace worn-out mufflers immediately. Continued use could result in fire or explosion.

GB - 19

Page 18 Page 20
Image 19
Page 18 Page 20
Contents Walk Behind Lawn Mower Introduction Table of ContentsProduct Registration Unauthorized Replacement Parts Dealer DeliveryDisclaimer Practices and Laws SafetySafety Alerts NotationsSafety Rules Safety Decals LocationsEmission Control System Wear appropriate hearing protection Emission Control System Certification Label Page Carton Contents AssemblyAssembly Controls and Features Cutting Height Adjustment Controls and FeaturesOperation Optional Controls Wheel Drive Control self-propelled models Speed Control self-propelled modelsSwivel Wheel Lock To add fuel to fuel tank Filling the Fuel Tank GasolineMower SET-UP Fuel StabilizerTo Mulch To BagGrass Bag Removal To Side DischargeStarting and Shut OFF Emergency StoppingCheck ENGINE/BLADE Control MaintenanceMaintenance Schedule Maintenance ScheduleCheck Engine OIL Clean UnitCheck Wheel Drive Control Check Grass BAGChange Engine OIL Check AIR CleanerCheck Drive Belt Check FastenersHandlebar Height Service and AdjustmentsService Position Drive Belt ReplacementNo slack To increase the gap Wheel Drive Control AdjustmentTo decrease the gap Speed Control Bell CrankStorage Troubleshooting Accessories Service Parts911193 911194 911170 911192 SpecificationsConsumer Mowing Equipment Limited Warranty Limitation of Remedy and Damages Your Warranty Rights and Obligations Disclaimer Evaporative Emission Warranty Parts ListAriens West Ryan Street Brillion, WI Fax Walk Behind Lawn Mower Entretien ET Pièces DE Rechange Table DES MatièresLE Manuel Manuel DU MoteurPièces DE Rechange NON Homologuées Enregistrement DU ProduitLimitation DE Responsabilité Usages ET Lois SécuritéConsignes DE Sécurité RemarquesSystème DE Contrôle DES Émissions Autocollants DE Sécurité ET EmplacementsPage Page Page Page Contenu MontageMontage Commandes ET Fonctions Fonctionnement Commandes ET FonctionsRéglage DE LA Hauteur DE Coupe Modèles avec roues pivotantes Modèles standardPoire d’amorçage 911192, 193 Commandes EN OptionCommande de vitesse modèles auto- tractés Commande d’entraînement modèles auto-tractésRéglage DE LA Tondeuse Remplissage DU Réservoir DE CarburantStabilisateur d’essence Paillis Pour ensacherDépose du sac à herbe Evacuation latéraleMise EN Marche ET Arrêt Arrêt D’URGENCEPériodicité DE L’ENTRETIEN Vérification DE LA Commande MOTEUR/LAMEEntretien Périodicité DE ’ENTRETIENVérifier LA Lame Vérification DU SAC a HerbeNettoyage DE LA Machine Vérification DE L’HUILE MoteurGraissage Général Vérification DE LA VisserieVérification DU Filtre À AIR Vidange DE L’HUILE MoteurPrudence Remplacer Entretien ET RéglagesVérification DES Bougies Position Pour L’ENTRETIENHauteur DU Guidon Remplacement DE LA Courroie D’ENTRAÎNEMENTModèles auto-tractés Auto-tractés TenduPour réduire l’espace Levier Coudé DE Commande DE Vitesse modèles auto-tractésMoteur RemisageNettoyage Sac à herbeDépannage Pas modèles La commande’entraînement Ne s’enclenchePièces DE Rechange AccessoiresSpécifications Extensions spéciales Limitations DE Recours ET DE Dommages VOS Droits ET Obligations Dans LE Cadre DE LA Garantie Déni de responsabilité Ariens West Ryan Street Brillion, WI Fax

911194 specifications

The Ariens 911194 is a powerful and efficient snow blower designed for residential use, specifically engineered to handle heavy snowfall with ease. As part of the Ariens brand, known for its reliable and durable outdoor power equipment, the 911194 lives up to high expectations, showcasing advanced technology and solid construction.

One of the standout features of the Ariens 911194 is its 24-inch clearing width, allowing users to quickly clear large areas of snow in a single pass. This makes the machine particularly effective for driveways, sidewalks, and large patios. The snow blower is equipped with a 208cc, 4-cycle engine, which provides ample power and robust performance. Its reliable engine starts smoothly in cold weather, ensuring that users can tackle any winter storm without delay.

The Ariens 911194 also features an innovative, adjustable chute that allows for precise control of snow direction. Operators can rotate the chute up to 200 degrees, making it easier to throw snow precisely where it needs to go. This feature is enhanced by a remote deflector that allows users to change the height of the snow stream without stopping the machine, increasing efficiency during operation.

Another key characteristic of the Ariens 911194 is its 6-speed forward and 2-speed reverse transmission. This variability enables users to easily navigate different snow conditions and terrains, ensuring optimal control and maneuverability. The heavy-duty construction includes a durable steel auger and housing, designed to withstand the harshest winter conditions and provide long-lasting performance.

Additionally, the snow blower comes with large, all-terrain tires, which provide excellent traction on icy or uneven surfaces. This ensures that users can operate the machine confidently, regardless of the conditions. Ergonomically designed handles and controls also enhance user comfort, making extended use more manageable.

In conclusion, the Ariens 911194 is a well-rounded snow blower that combines power, efficiency, and user-friendly features. Its robust engine, versatile controls, and durable construction make it an excellent choice for homeowners looking to manage winter's challenges effectively. With the technology and features included, it stands as a reliable investment for maintaining clear and safe outdoor spaces during snowy months.
Top Page Image Contents