Ariens 911194 warranty Your Warranty Rights and Obligations

Page 30

CALIFORNIA AND EPA (UNITED STATES ENVIRONMENTAL PROTECTION AGENCY) EVAPORATIVE EMISSION CONTROL WARRANTY STATEMENT

YOUR WARRANTY RIGHTS AND OBLIGATIONS

The CARB (California Air Resources Board), the EPA, and Ariens Company are pleased to explain the evaporative emission control system's warranty on your 2012 model year small off-road equipment. In California, new equipment that uses small off-road engines must be designed, built, and equipped to meet the State's stringent anti-smog standards. Ariens Company must warrant the evaporative emission control system on your small off-road equipment for the period listed below provided there has been no abuse, neglect or improper maintenance of your equipment.

Your evaporative emission control system may include parts such as: fuel tanks, fuel lines, fuel caps, valves, canisters, filters, vapor hoses, clamps, connectors, and other associated components.

MANUFACTURER'S WARRANTY COVERAGE:

This evaporative emission control system is warranted for two years. If any evaporative emission-related part on your equipment is defective, the part will be repaired or replaced by Ariens Company.

OWNER'S WARRANTY RESPONSIBILITIES:

•As the small off-road equipment owner, you are responsible for the performance of the required maintenance listed in your Owner's Manual. Ariens Company recommends that you retain all receipts covering maintenance on your small off-road equipment, but Ariens Company cannot deny warranty solely for the lack of receipts.

•As the small off-road equipment owner, you should however be aware that the Ariens Company may deny you warranty coverage if your evaporative emission control system part has failed due to abuse, neglect, or improper maintenance or unapproved modifications.

•You are responsible for presenting your small off-road equipment to an authorized Ariens, Gravely, or Parker service representative as soon as the problem exists. The warranty repairs should be completed in a reasonable amount of time, not to exceed 30 days. If you have a question regarding your warranty coverage, you should contact Ariens Company Technical Service Center at 1-920-756-2141.

DEFECTS WARRANTY REQUIREMENTS:

(a.)

The warranty period begins on the date the small off-road equipment is delivered to an ultimate

 

purchaser.

(b.)

General Evaporative Emissions Warranty Coverage. Ariens Company warrants to the ultimate

 

purchaser and any subsequent owner that the evaporative emission control system when

 

installed was:

 

(1.) Designed, built, and equipped so as to conform with all applicable EPA and CARB

 

regulations; and

 

(2.) Free from defects in materials and workmanship that causes the failure of a warranted part

 

for a period of two years.

(c.)

The warranty on evaporative emissions-related parts will be interpreted as follows:

 

(1.) Any warranted part that is not scheduled for replacement as required maintenance in the

 

written instructions must be warranted for the warranty period defined in subsection (b)(2).

 

If any such part fails during the period of warranty coverage, it must be repaired or replaced

 

by the Ariens Company. Any such part repaired or replaced under the warranty must be

 

warranted for a time not less than the remaining warranty period.

 

(2.) Any warranted part that is scheduled only for regular inspection in the written instructions

 

must be warranted for the warranty period defined in subsection (b)(2). A statement in such

 

written instructions to the effect of "repair or replace as necessary" will not reduce the

 

period of warranty coverage. Any such part repaired or replaced under warranty must be

 

warranted for a time not less than the remaining warranty period.

 

(3.) Any warranted part that is scheduled for replacement as required maintenance in the

 

written instructions must be warranted for the period of time prior to the first scheduled

 

replacement point for that part. If the part fails prior to the first scheduled replacement, the

 

part must be repaired or replaced by the Ariens Company. Any such part repaired or

 

replaced under warranty must be warranted for a time not less than the remainder of the

 

period prior to the first scheduled replacement point for the part.

 

 

CARB/EPA 2012

 

 

 

30

Page 29 Page 31
Image 30
Page 29 Page 31
Contents Walk Behind Lawn Mower Table of Contents IntroductionUnauthorized Replacement Parts Dealer Delivery Product RegistrationDisclaimer Notations SafetySafety Alerts Practices and LawsSafety Decals Locations Safety RulesEmission Control System Wear appropriate hearing protection Emission Control System Certification Label Page Assembly Carton ContentsAssembly Controls and Features Controls and Features Cutting Height AdjustmentOperation Optional Controls Speed Control self-propelled models Wheel Drive Control self-propelled modelsSwivel Wheel Lock Fuel Stabilizer Filling the Fuel Tank GasolineMower SET-UP To add fuel to fuel tankTo Side Discharge To BagGrass Bag Removal To MulchEmergency Stopping Starting and Shut OFFMaintenance Schedule MaintenanceMaintenance Schedule Check ENGINE/BLADE ControlCheck Grass BAG Clean UnitCheck Wheel Drive Control Check Engine OILCheck Fasteners Check AIR CleanerCheck Drive Belt Change Engine OILDrive Belt Replacement Service and AdjustmentsService Position Handlebar HeightNo slack Wheel Drive Control Adjustment To increase the gapSpeed Control Bell Crank To decrease the gapStorage Troubleshooting Service Parts AccessoriesSpecifications 911193 911194 911170 911192Consumer Mowing Equipment Limited Warranty Limitation of Remedy and Damages Your Warranty Rights and Obligations Evaporative Emission Warranty Parts List DisclaimerAriens West Ryan Street Brillion, WI Fax Walk Behind Lawn Mower Manuel DU Moteur Table DES MatièresLE Manuel Entretien ET Pièces DE RechangeEnregistrement DU Produit Pièces DE Rechange NON HomologuéesLimitation DE Responsabilité Remarques SécuritéConsignes DE Sécurité Usages ET LoisAutocollants DE Sécurité ET Emplacements Système DE Contrôle DES ÉmissionsPage Page Page Page Montage ContenuMontage Commandes ET Fonctions Commandes ET Fonctions FonctionnementRéglage DE LA Hauteur DE Coupe Modèles standard Modèles avec roues pivotantesCommande d’entraînement modèles auto-tractés Commandes EN OptionCommande de vitesse modèles auto- tractés Poire d’amorçage 911192, 193Remplissage DU Réservoir DE Carburant Réglage DE LA TondeuseStabilisateur d’essence Evacuation latérale Pour ensacherDépose du sac à herbe PaillisArrêt D’URGENCE Mise EN Marche ET ArrêtPériodicité DE ’ENTRETIEN Vérification DE LA Commande MOTEUR/LAMEEntretien Périodicité DE L’ENTRETIENVérification DE L’HUILE Moteur Vérification DU SAC a HerbeNettoyage DE LA Machine Vérifier LA LameVidange DE L’HUILE Moteur Vérification DE LA VisserieVérification DU Filtre À AIR Graissage GénéralPosition Pour L’ENTRETIEN Entretien ET RéglagesVérification DES Bougies Prudence RemplacerRemplacement DE LA Courroie D’ENTRAÎNEMENT Hauteur DU GuidonModèles auto-tractés Tendu Auto-tractésLevier Coudé DE Commande DE Vitesse modèles auto-tractés Pour réduire l’espaceSac à herbe RemisageNettoyage MoteurDépannage Ne s’enclenche La commande’entraînement Pas modèlesAccessoires Pièces DE RechangeSpécifications Extensions spéciales Limitations DE Recours ET DE Dommages VOS Droits ET Obligations Dans LE Cadre DE LA Garantie Déni de responsabilité Ariens West Ryan Street Brillion, WI Fax

911194 specifications

The Ariens 911194 is a powerful and efficient snow blower designed for residential use, specifically engineered to handle heavy snowfall with ease. As part of the Ariens brand, known for its reliable and durable outdoor power equipment, the 911194 lives up to high expectations, showcasing advanced technology and solid construction.

One of the standout features of the Ariens 911194 is its 24-inch clearing width, allowing users to quickly clear large areas of snow in a single pass. This makes the machine particularly effective for driveways, sidewalks, and large patios. The snow blower is equipped with a 208cc, 4-cycle engine, which provides ample power and robust performance. Its reliable engine starts smoothly in cold weather, ensuring that users can tackle any winter storm without delay.

The Ariens 911194 also features an innovative, adjustable chute that allows for precise control of snow direction. Operators can rotate the chute up to 200 degrees, making it easier to throw snow precisely where it needs to go. This feature is enhanced by a remote deflector that allows users to change the height of the snow stream without stopping the machine, increasing efficiency during operation.

Another key characteristic of the Ariens 911194 is its 6-speed forward and 2-speed reverse transmission. This variability enables users to easily navigate different snow conditions and terrains, ensuring optimal control and maneuverability. The heavy-duty construction includes a durable steel auger and housing, designed to withstand the harshest winter conditions and provide long-lasting performance.

Additionally, the snow blower comes with large, all-terrain tires, which provide excellent traction on icy or uneven surfaces. This ensures that users can operate the machine confidently, regardless of the conditions. Ergonomically designed handles and controls also enhance user comfort, making extended use more manageable.

In conclusion, the Ariens 911194 is a well-rounded snow blower that combines power, efficiency, and user-friendly features. Its robust engine, versatile controls, and durable construction make it an excellent choice for homeowners looking to manage winter's challenges effectively. With the technology and features included, it stands as a reliable investment for maintaining clear and safe outdoor spaces during snowy months.
Top Page Image Contents