Ariens 911194 warranty Emission Control System Certification Label

Page 7

ALWAYS shut off engine, allow blade to stop and disconnect spark plug wire before clearing clogs or cleaning unit.

Check grass bag for wear, damage, and/or deterioration. Replace only with Ariens original equipment replacement parts for safety.

To reduce fire hazard and overheating, keep equipment free of grass, leaves, debris or excessive lubricants.

Use extra care when approaching blind corners, shrubs, trees, or other objects which may obscure vision.

DO NOT mow at too fast a rate. DO NOT change engine governor setting or over- speed the engine.

Do not operate mower on gravel or loose material such as sand. Stop mower when crossing drives, walks, or roads to prevent damage or injury from thrown objects.

DO NOT pull mower backwards unless absolutely necessary. Look down and back, especially for small children, before and while moving backwards.

On self-propelled models, releasing wheel drive control must stop mower’s forward movement. If this feature fails to operate, disconnect spark plug wire and repair before using unit.

On self-propelled models, wheel drive must be disengaged when starting engine.

DO NOT operate on steep slopes.

NEVER leave unit unattended on a slope. Chock wheels if parking on a slope.

Mow across the face of slopes, never up and down. Be especially cautious when changing direction on slopes.

This product is equipped with an internal combustion engine. DO NOT use on or near any unimproved, forest or brush covered land unless the exhaust system is equipped with a spark arrestor meeting applicable local, state or federal laws. A spark arrestor, if used, must be maintained in effective working order by the operator. See your Ariens Dealer or engine manufacturer’s service center.

Emission Control System

Certification Label

NOTE: Tampering with emission controls and components by unauthorized personnel may result in severe fines or penalties. Emission controls and components can only be adjusted by EPA and/or CARB authorized service centers. Contact your Ariens Equipment Retailer concerning emission controls and component questions.

Fuel is highly flammable and its vapors can explode. ONLY use approved fuel containers.

•NO Smoking!

•NO Sparks!

•NO Flames!

•Allow engine to cool before filling fuel tank.

Never fill containers inside a vehicle or on a truck or trailer bed with a plastic liner. Always place containers on the ground away from your vehicle before filling.

When practical, remove gas-powered equipment from the truck or trailer and refuel it on the ground. If this is not possible, then refuel such equipment on a trailer with a portable container, rather than from a gasoline dispenser nozzle.

Keep the nozzle in contact with the rim of the fuel tank or container opening at all times until fueling is complete. Do not use a nozzle lock- open device.

Check fuel supply before starting engine.

DO NOT fill gasoline tank indoors, when engine is running, or while engine is hot.

Allow engine to cool several minutes before removing fuel cap.

DO NOT overfill. Allow about 1/4" (6 mm) of tank space for fuel expansion.

Replace gasoline tank cap securely and clean any spilled fuel before starting engine.

If fuel is spilled on clothing, change clothing immediately.

NEVER store fuel inside where there is an open flame, such as a water heater.

ALWAYS drain fuel outdoors away from ignition sources.

ALWAYS shut off engine, and remove key, and close fuel shutoff valve when transporting unit on a truck or trailer.

Avoid Electric Shock. DO NOT disconnect wire from spark plug while engine is running.

Do NOT put battery in fire or mutilate. Explosive Gases!

NO flames, NO sparks, NO smoking, near battery.

Poisonous battery fluid contains sulfuric acid. Contact with skin, eyes or clothing can cause severe chemical burns.

ALWAYS wear safety glasses and protective gear near battery.

ALWAYS keep batteries out of reach of children.

GB - 7

Page 6 Page 8
Image 7
Page 6 Page 8
Contents Walk Behind Lawn Mower Introduction Table of ContentsProduct Registration Unauthorized Replacement Parts Dealer DeliveryDisclaimer Practices and Laws SafetySafety Alerts NotationsSafety Rules Safety Decals LocationsEmission Control System Wear appropriate hearing protection Emission Control System Certification Label Page Carton Contents AssemblyAssembly Controls and Features Cutting Height Adjustment Controls and FeaturesOperation Optional Controls Wheel Drive Control self-propelled models Speed Control self-propelled modelsSwivel Wheel Lock To add fuel to fuel tank Filling the Fuel Tank GasolineMower SET-UP Fuel StabilizerTo Mulch To BagGrass Bag Removal To Side DischargeStarting and Shut OFF Emergency StoppingCheck ENGINE/BLADE Control MaintenanceMaintenance Schedule Maintenance ScheduleCheck Engine OIL Clean UnitCheck Wheel Drive Control Check Grass BAGChange Engine OIL Check AIR CleanerCheck Drive Belt Check FastenersHandlebar Height Service and AdjustmentsService Position Drive Belt ReplacementNo slack To increase the gap Wheel Drive Control AdjustmentTo decrease the gap Speed Control Bell CrankStorage Troubleshooting Accessories Service Parts911193 911194 911170 911192 SpecificationsConsumer Mowing Equipment Limited Warranty Limitation of Remedy and Damages Your Warranty Rights and Obligations Disclaimer Evaporative Emission Warranty Parts ListAriens West Ryan Street Brillion, WI Fax Walk Behind Lawn Mower Entretien ET Pièces DE Rechange Table DES MatièresLE Manuel Manuel DU MoteurPièces DE Rechange NON Homologuées Enregistrement DU ProduitLimitation DE Responsabilité Usages ET Lois SécuritéConsignes DE Sécurité RemarquesSystème DE Contrôle DES Émissions Autocollants DE Sécurité ET EmplacementsPage Page Page Page Contenu MontageMontage Commandes ET Fonctions Fonctionnement Commandes ET FonctionsRéglage DE LA Hauteur DE Coupe Modèles avec roues pivotantes Modèles standardPoire d’amorçage 911192, 193 Commandes EN OptionCommande de vitesse modèles auto- tractés Commande d’entraînement modèles auto-tractésRéglage DE LA Tondeuse Remplissage DU Réservoir DE CarburantStabilisateur d’essence Paillis Pour ensacherDépose du sac à herbe Evacuation latéraleMise EN Marche ET Arrêt Arrêt D’URGENCEPériodicité DE L’ENTRETIEN Vérification DE LA Commande MOTEUR/LAMEEntretien Périodicité DE ’ENTRETIENVérifier LA Lame Vérification DU SAC a HerbeNettoyage DE LA Machine Vérification DE L’HUILE MoteurGraissage Général Vérification DE LA VisserieVérification DU Filtre À AIR Vidange DE L’HUILE MoteurPrudence Remplacer Entretien ET RéglagesVérification DES Bougies Position Pour L’ENTRETIENHauteur DU Guidon Remplacement DE LA Courroie D’ENTRAÎNEMENTModèles auto-tractés Auto-tractés TenduPour réduire l’espace Levier Coudé DE Commande DE Vitesse modèles auto-tractésMoteur RemisageNettoyage Sac à herbeDépannage Pas modèles La commande’entraînement Ne s’enclenchePièces DE Rechange AccessoiresSpécifications Extensions spéciales Limitations DE Recours ET DE Dommages VOS Droits ET Obligations Dans LE Cadre DE LA Garantie Déni de responsabilité Ariens West Ryan Street Brillion, WI Fax

911194 specifications

The Ariens 911194 is a powerful and efficient snow blower designed for residential use, specifically engineered to handle heavy snowfall with ease. As part of the Ariens brand, known for its reliable and durable outdoor power equipment, the 911194 lives up to high expectations, showcasing advanced technology and solid construction.

One of the standout features of the Ariens 911194 is its 24-inch clearing width, allowing users to quickly clear large areas of snow in a single pass. This makes the machine particularly effective for driveways, sidewalks, and large patios. The snow blower is equipped with a 208cc, 4-cycle engine, which provides ample power and robust performance. Its reliable engine starts smoothly in cold weather, ensuring that users can tackle any winter storm without delay.

The Ariens 911194 also features an innovative, adjustable chute that allows for precise control of snow direction. Operators can rotate the chute up to 200 degrees, making it easier to throw snow precisely where it needs to go. This feature is enhanced by a remote deflector that allows users to change the height of the snow stream without stopping the machine, increasing efficiency during operation.

Another key characteristic of the Ariens 911194 is its 6-speed forward and 2-speed reverse transmission. This variability enables users to easily navigate different snow conditions and terrains, ensuring optimal control and maneuverability. The heavy-duty construction includes a durable steel auger and housing, designed to withstand the harshest winter conditions and provide long-lasting performance.

Additionally, the snow blower comes with large, all-terrain tires, which provide excellent traction on icy or uneven surfaces. This ensures that users can operate the machine confidently, regardless of the conditions. Ergonomically designed handles and controls also enhance user comfort, making extended use more manageable.

In conclusion, the Ariens 911194 is a well-rounded snow blower that combines power, efficiency, and user-friendly features. Its robust engine, versatile controls, and durable construction make it an excellent choice for homeowners looking to manage winter's challenges effectively. With the technology and features included, it stands as a reliable investment for maintaining clear and safe outdoor spaces during snowy months.
Top Page Image Contents