WHIRLPOOL USER INFORMATION
PLEASE NOTE:
The whirlpool action may cause even small amounts of bubble bath or shampoo to foam excessively. Exercise moderation in experimenting with different soap products.
No servicing of this product should be done by the user. There are no user serviceable parts. All controls are located in the control recesses on the lip of the tub. These are the only controls that should be used by the consumer. Do not change or alter any of these controls under any circumstances.
Motors are
FCC CONSUMER INFORMATION
Electrical Installation Information Listed on pages 12-15.
This equipment generates and uses radio frequency energy and if not installed and used properly, that is, in strict accordance with the manufacturers instruction, may cause interference to radio and television reception. It has been type tested and found to comply with the limits for a class B computing device in accordance with the specifications in subpart J of part 15 of the FCC rules, which are designed to provide reasonable protection against such interference in a residential installation. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause interference, which can be determined by turning the equipment on and off, the user is encouraged to try to correct the interference by one or more of the following measures:
•Reorient the receiving antenna.
•Relocate the receiver with respect to the bath tub.
•Move the receiver away from the bath.
•Plug the receiver into a different outlet so that the receiver and bath are on different branch circuits.
•If necessary, the user should consult the dealer or an experienced radio/television technician for additional suggestions.
•The user may find the following booklet prepared by the Federal Communications Commission helpful: “How To Identify and Resolve
This booklet is available from the U.S. Government Printing Office, Washington, DC 20402, Stock No.,
Serial Number Location
The tub model and serial numbers are located above the pump area on the backside of the bathtub. Your installer should have a service access panel in this location. Look for a label which resembles the one on the right.
22 | AQUATIC INDUSTRIES, INC. |