Alamo 02984405 instruction manual Dipper

Valve Remote Cable Controls

10.Connect Cable to Control Handle. Install the cable locking nut onto the threaded cable (See Figure 7), screw the nut on leaving enough threads to fully screw the control handle to the cable. Push the handle of the control assembly all the way to one side and the threaded shaft of the handle will be visible at the bottom (See Figure 8). After the handle is screwed onto the cable, tighten the cable locking nut against the handle control. Push the control handle to the straight position (See Figure 9), while pushing the cable into the handle asy. When the cable is inserted into the handle assembly until the groove in the cable housing is aligned with the retaining screw hole of handle housing assembly insert the retaining screw and nut (See Figure 9)

11.Stack Control Handles. Each cable control handle will attach to the cable in the same way. The control handles will be stacked together in the proper order (See Figure 5 & 10). These control handles will be stacked with the mounting brackets and electrical switch brackets between them. Where the brackets are located in the group can vary. Shown in figure 10 is the recommended placement of these brackets. The bracket that mounts the control handles is slotted to allow for the adjustment of the angle of the control handle assemblies.

12.The "ON" / "OFF" Switch is bolted to the Control Handles. This is a good place but can be mounted somewhere else is desired. If Mounted somewhere else keep in mind it must be accessible quickly by the operator in case of emergency needs. (See Figure 10)

Cable retaining screw	Cable Housing
& nut installed	inserted into
	hamdle asy

Figure 9

	Cable Retaining
	Screw Groove
Cable	Threaded
	Cable End
locking	Cable Housing
Nut
Figure 7

Handle Out of

Neutral Position

Cable Retaining

Screw & Nut

Cable Housing

Figure 8

	Dipper
Lift	Tilt
Swing	Door / Swivel
"ON" "OFF"
Switch
Figure 10

Axtreme Boom (Asy Man) 07/06

© 2006 Alamo Industrial Section 8 - 7