Your spa will perform a self-diagnostic check and go into priming mode. When the control panel displays PR, do the following:
a. Press the JETS button to turn on the pump and let it run for 10 seconds. The pump should be running in low speed.
When the spa is filled to the correct level, turn on the power at the GFCI breaker. (Ensure that the 120V spas are connected to the proper electrical outlet.)
b. Press the JETS buttons again and let the pump run in high speed for 10 seconds.
c. Press the JETS button again to turn off the pump. The pump should be left off for 10 to 15 seconds.
d. Repeat steps a through c until water is flowing through all the jets and all air is removed from the plumbing.
If spa fails to prime, there could be an air pocket at the suction side of the pump. Follow the priming instructions on page 11 using the bleeder valve.
Make sure the filter has soaked at least 30 minutes before you install it.
10
Preparing forYour New Portable Spa
4.Turn on power to the spa..
5.Prime the pump..
6.Install the filter into the filter canister.
7.Let the spa heat up..
When the spa has finished priming, the heater will activate.
Put the cover on and let the spa run for two hours.
8.Adjust water chemistry.
After the spa has run for two hours, test and adjust the water chemistry. See the section on page 23 for instructions on water clarity.
2011 Portable Spa
www.calspas.com | LTR20111000, Rev. D |