Cal Spas LTR20111000 manual Symptom Water Problems, Possible Causes Possible Solutions

Symptom

Water Problems

Water is not clean

High water consumption

Low water stream from the jets

No water stream from the jets

Water leakage from below the spa

Water Pressure Problems

Jets surge on and off

Jets are weaker than normal or do not work at all

Air and Jets Problems

No airstream from the jets

Light Problems

Standard spa light does not work

Possible Causes Possible Solutions

For all water clarity problems, see page 21.

Very high evaporation or heavy	Use the cover and refill as necessary
splashing
Running in FILTER mode - slow	Select high speed jets
speed
Block wall suctions or skimmer	Clean the wall suction/skimmer. Remove
	blockage
Dirty filter	Clean filter and replace
Jets are closed	Open jets
Valves closed	Open valves
Pump has airlock	Remove airlock by priming spa (page 11)
Jets are closed	Open jets
Power switched off, system off	Reset power
Pump is defective	Contact your dealer
Pump fluctuations	Low water. Check level on skimmer flap
Check the connections and empty	Close or turn off empty cycle if necessary
the hoses
Water level is too low	Add water to normal level
Jet valves are partially or fully closed	Open jet valves
Filter cartridge is dirty	See Cleaning the Filter
Air is trapped in the pump	Open the air bleed valve on each pump’s
	housing and allow air to bleed out of the
	system. Be sure to tighten each air bleed
	valve as soon as water starts to flow.
The suction fittings are blocked	Remove any debris that may be blocking
	the suction fittings
Gate valve is closed	Open gate valves. Note: Never operate your
	spa with the gate valves closed!
Air control not open	Open the control
Jet spout opening not fixed properly	Check jet spout openings
Jet spout opening missing	Check jets and replace as necessary
Light bulb has burned out	Replace light bulb
Lighting system is defective	Contact your dealer

47 Appendix

2011 Portable Spa

LTR20111000, Rev. D www.calspas.com