Cal Spas LTR20111000 Jet Operation One Pump Systems, Jet Operation Two and Three Pump Systems

Page 15

Jet Operation: One Pump Systems

Single pump systems operate on high power only. To operate the jets, press the JETS button:

Once to turn the pump ON.

Twice to turn the pump OFF.

Jet Operation: Two and Three Pump

Systems

Two and three pump systems can be configured to operate on low or high power. The factory default is low power. This section describes how the spa operates when it is configured for low power operation.

See page 6 for GFCI and wiring requirements for both low and high power operation, and page 7 for switch settings for high power configuration.

Spas configured for low power operation require approximately 20% less power to operate. With low power configuration, the spa will never use more than 30 amps while in operation and will alternate between 110V and 220V, while spas configured for high power will operate continuously at 220V.

When only one pump is running, the heater will operate at 220V. When two or three pumps are running, the heater will automatically switch to operate at 110V.

The heater light will tell you when it is operating and what voltage it is using. See the “Heater Light” section above.

For spas configured for high power operation, the heater will turn on when (1) the water temperature drops or (2) the jets are in use.

Operating the jets

Press the JETS or JETS 1 button:

Once to turn pump 1 ON.

Twice to turn pump 1 OFF.

Press the JETS 2 or OPTION button:

Once to turn pump 2 ON.

Twice to turn pump 3 ON.

Three times to turn pump 2 OFF.

Four times to turn pump 2 OF.

2011 Portable Spa

Heater Light

The heater light will turn on whenever the heater is operating. It will appear three different ways when the spa is operating:

A steady light means that the spa is operating at 220V.

A slowly blinking light means that the spa is operating at 120V.

A rapidly flashing light means that the heater is reading the water temperature. When the temperature has been determined, the heater light will stop flashing. You will frequently see the heater light flashing rapidly while it is also steady or slowly blinking.

Heating Modes

The spa can be set to operate in three different heating modes:

Standard: When the spa is powered up, it will automatically start in Standard heating mode. In Standard mode, the heating system will automatically maintain the set spa temperature.

STD or ST will light briefly on the main display.

Economy: In Economy mode, the heating system will only activate during filtration times and will heat the water to the set temperature. Ecn or Ec will display solid if temperature is not current and will alternate with spa temperature if measured temperature is current.

Sleep: In Sleep mode, the heating system will only activate the heater during the filtering cycles but will only heat the water to within 20°F (10°C) of the set temperature. Like Economy mode, SLP or SL will display solid when temperature is not current and will alternate with actual temperature when it is current.

NOTE: Displayed temperature will only be current after the pump has been running for at least two minutes.

Switching Heating Modes

Press Temp button followed by the Light button.

Press the same sequence to switch to the next mode.

13 OperatingYour

Spa

LTR20111000, Rev. D

www.calspas.com

Image 15
Contents LTR20111000, Rev. D 9/14/11 Appendix Cleaning and MaintenanceUsing the Entertainment System Operating Your SpaThis First Important Safety InstructionsRead First!This Preparing for Your New Portable Spa Planning the Best LocationForYour New Portable Spa Preparing a Good Foundation Preparing forYour New Portable SpaTesting the Gfci Volt Electrical InstallationGfci and Wiring Requirements Testing the Gfci Breaker240V Gfci and Wiring Requirements Control System Power Setting Gfci Required Wires RequiredWires Required Spa Model A10 High Power ConfigurationElectrical Installation for 11 kW Heater OFF Position Down On Position UpGfci Wiring Diagram Filling and Powering Up Your Portable Spa Your New PortableSpa Adjust water chemistry New Portable Spa Using the control panelUsing the bleeder valve Priming the PumpInitial Start up Operating Your SpaOperating SpaYour 5100DV, 6200DV, and 6300DV Electronic Control OperationHeater Light Switching Heating ModesJet Operation One Pump Systems Jet Operation Two and Three Pump SystemsElectronic Control Auxiliary controls for the 9800 system OperationJets Setting the Temperature LockTime Standard, Economy, Sleep, and Standby ModesOzone Circulation Pump Clean up CyclePreset Filter Cycles Your SpaDiagnostic Messages Periodic Reminder MessagesMessage Frequency Action Required Message Meaning Action Required Snb SnsStby Electrical Power Efficiency Jets OperatingYourLED Perimeter Lighting Diverter Knobs Hydro Streamer Waterfall WaterfallsAir Venturis Wireless Spa Monitor Adjustable Therapy SystemWater Clarity Key to Clear WaterWater Clarity Balancing the Calcium Hardness Testing and Adjusting Spa WaterBalancing the Total Alkalinity Balancing the pHSanitation Using Chlorine as a SanitizerChemical Safety About the Pure XL Water SanitizerShocking the Water Filter Cleaning OzonatorBather Load Spa capacity gallons Maintenance level Cal Clarity II Bromine GeneratorStarting the Spa with Fresh Water Operating Modes Cal Clarity II SettingsTesting the Water Adding BromiCharge to the WaterMaintenance Schedule Clarity Troubleshooting Water Clarity ProblemsCleaning and Maintenance Removing and Reseating the PillowsSpa Cover Draining Your Portable Spa Cleaning and Replacing the FilterContinuous water flow and drainage Freeze damage is not covered by your warrantyWinterizing Cold Climate Draining Vacation CareSpa Shell Cleaning Your SpaJet Removal and Replacement Spa Cover and PillowsInserting and Ejecting a Disk Using the Entertainment SystemListening to the Radio Playing a CDSystem Using the EntertainmentSynchronizing the Remote Control with the Docking Station IPod Docking StationAir Control Valve Replacement PartsAppendix WaterfallsFilters Water Diverter ValvesDrains PillowsReplacement Cabinet Panels Pure XL UV Water SanitizerLED Lights Covers Diamond SeriesEscape Series ES848B / ES848L / ES861B 93 x ES861L / ES864B / ES864L Family SeriesPlatinum Series Fitness SeriesUltimate Fitness Series Exercise Program Keeping Fit with your SpaConnecting the Exercise Equipment Symptom Possible Causes Possible Solutions TroubleshootingPossible Causes Possible Solutions Symptom Water ProblemsPump does not work Symptom Possible Causes Possible Solutions Pump ProblemsPortable Spas Limited WarrantyActs That Will Void This Warranty Manufacturer WarrantyAuthorized Repairs and Service Proration of WarrantyLegal Remedies Customer ServiceExclusions DisclaimersPortable Spa Portable Spa Locating the product serial number Warranty Registration