Maintenance
Figure 12
1.Positive (+) cable on discharged battery
2.Positive (+) cable on booster battery
3.Negative
4.Negative
5.Booster battery
6.Discharged battery
7.Engine block
Figure 13
1.Install bushing in blade prior to installing bushing in spindle.
B.Install bushing/blade assembly into spindle.
4. | Connect the other end of the positive cable to the |
| positive terminal of the booster battery. |
5. | Connect the black negative |
| terminal (negative) of the booster battery. |
6. | MAKE THE FINAL CONNECTION ON |
| THE ENGINE BLOCK OF THE STALLED |
| VEHICLE (NOT TO THE NEGATIVE POST) |
Figure 14
AWAY FROM THE BATTERY. STAND BACK. |
7. Start the vehicle and remove the cables in the |
reverse order of connection (the engine block |
(black) connection is the first to disconnect). |
Check Mower Blades
1.Use wrench here for blade installation. This nut has been torqued to
2.Torque to
Service Interval: Before each use or daily
1.Stop engine, wait for all moving parts to stop, and remove key. Engage parking brake.
2.Lift deck and secure in raised position as stated in the Clean Grass
3.Inspect blades and sharpen or replace as required.
4.Reinstall the blades (if they were removed) in the following order:
A.Install bushing through blade with bushing flange on bottom (grass) side of blade.
C.Apply lubricant to threads of blade bolt as needed to prevent seizing.
31