Exmark 4500-540 Rev. B manual See EXMARK’S Complete Line of Accessories and Options

Page 48

SEE EXMARK’S COMPLETE LINE OF ACCESSORIES AND OPTIONS

MID-MOUNT RIDING ACCESSORIES AND OPTIONS

CUSTOM RIDE SEAT SUSPENSION SYSTEM

OPERATOR CONTROLLED DISCHARGE

FULL SUSPENSION SEAT

ROLL OVER PROTECTION SYSTEM (ROPS)

DECK LIFT ASSIST KIT

SUN SHADE

HITCH KIT

TRASH CONTAINER

LIGHT KIT

TURF STRIPER

12V POWER PORT

ULTRA VAC COLLECTION SYSTEM

MICRO-MULCH SYSTEM

ULTRA VAC QUICK DISPOSAL SYSTEM

OUT-FRONT RIDING ACCESSORIES AND OPTIONS

CUSTOM RIDE SEAT SUSPENSION SYSTEM

SNOW BLADE

DUAL-TAIL WHEEL

SNOWBLOWER

FLOOR PAN EXTENDER

SUN SHADE

HITCH KIT

TRASH CONTAINER

LIGHT KIT

ULTRA VAC COLLECTION SYSTEM

MICRO-MULCH SYSTEM

ULTRA VAC QUICK DISPOSAL SYSTEM

ROLL OVER PROTECTION SYSTEM (ROPS)

WEATHER CAB

WALK-BEHIND ACCESSORIES AND OPTIONS

GRASS CATCHER

MICRO-MULCH SYSTEM

Place Model No. and Serial No.

Label Here (Included in the Literature

Pack) or Fill in Below

Model No.

Serial No.

TURF STRIPER

STANDON

Date Purchased

Engine Model No. and Spec. No.

Engine Serial No. (E/No)

©2010 Exmark Mfg. Co., Inc.

Part No. 4500-540 Rev. B

Industrial Park Box 808

(402) 223-6300

Beatrice, NE 68310

Fax (402) 223-5489

All Rights Reserved

Printed in the USA

www.exmark.com

Image 48
Contents Turf Tracer HP California Introduction Contents Safety Safety Alert SymbolSafe Operating Practices TrainingSafety Operation Slope OperationMaintenance and Storage Safety Safety and Instructional Decals 413327 103-1977 109-3148 116-0404 117-2718 Specifications Model NumbersSystems Dimensions Product Overview Torque RequirementsOperation ControlsOff-Run Switch Manual Start Only Ignition Switch Electric Start OnlyTracking Adjustment Knob Park Brake LeverPre-Start Operating InstructionsOpen the Fuel Shut-Off Valve Starting the Engine Manual StartDisengaging the PTO Stopping the EngineDriving the Machine Drive Lever/Neutral Lock Latch OperationAdjusting the Cutting Height Driving ForwardDriving in Reverse Adjusting the Anti-Scalp Rollers Transporting Transporting a UnitMaintenance Recommended Maintenance SchedulesCheck Battery Charge Electric Start Units Only Check Engine Oil LevelProposition 65 Warning Service Interval As required Do Not jump start a weak battery if these conditions existInstall bushing/blade assembly into spindle Check Mower BladesReplacing the Discharge Deflector Check Safety Interlock System Service Air CleanerCheck for Loose Hardware Change Engine Oil Check Hydraulic Oil LevelCheck Tire Pressures Check Condition Of BeltsCheck Spark Plugs Change Fuel FilterChange Hydraulic System Filter LevelHydraulic System Air Purge Wheel Hub-Slotted Nut Torque Specification Inspect PTO Clutching Belt TensionThread Locking Adhesives Park Brake Adjustment Hydro Drive Linkage AdjustmentMobil HTS Grease Or Food-Grade Anti-seize Deck LevelingAdjust Neutral Control Linkages Adjust Hydro Control LinkagesDrive Lever Linkage Adjustment Tracking Adjustment Hydro Pump Spring Tension SettingPTO Safety Switch Retighten PTO switch mounting hardwareClean Engine and Exhaust System Area Remove Engine Shrouds and Clean Cooling FinsClean Debris From Machine Clean Grass Build-Up Under DeckMaintenance Troubleshooting Problem Possible Cause Corrective ActionTroubleshooting Schematics Electrical DiagramHydraulic Diagram Exmark Commercial Turf Equipment Page Service Record Date Description of Work Done Service Done ByPage This page may be copied for personal use See EXMARK’S Complete Line of Accessories and Options