Husqvarna 260 ACX manual Trouble Shooting

Page 71

9. TROUBLE SHOOTING

Fault message	Cause	Action


Outside working area	If this occurs in isolated areas it may	Try moving the boundary wire.
	be due to interference from metallic
	objects (perimeter fence,
	reinforcement bar) or buried cables in
	the vicinity.

	The working area slopes too much.	Check that the boundary wire has
		been routed correctly.

	The boundary wire has been routed	Check that the boundary wire has
	the wrong way around an island.	been routed in accordance with the
		installation instructions.

	The boundary wire is too close to the	Check that the boundary wire has
	edge of the working area.	been routed correctly.

Low battery voltage	Automower® cannot find the charging	Change the search settings
	station.	according to the Follow loop in (3-2-2)
		on page 51.

		Change the position of the charging
		station.

	The battery is spent.	Expected life is 1 - 4 years. Contact
		your dealer to replace the battery.

Wrong PIN code	Wrong PIN code has been entered.	Enter the correct PIN code.
	Three attempts are permitted, the
	keypad is then blocked for five
	minutes.

No drive	Automower® has got caught in	Free the mower and rectify the
	something.	reason for the lack of drive. If it is due
		to wet grass, wait until the lawn has
		dried before using the mower.

No contact in charging	Automower® makes poor contact with	Check that Automower® has docked
station	the contact strips in the charging	correctly in the charging station.
	station.

Charging station	The contact between the charging	Place Automower® in the charging
blocked	strips and contact strips may be poor	station and check that the charging
	and Automower® has made a number	strips and contact strips make good
	of charging attempts.	contact.

	An object is obstructing Automower®.	Remove the object.

Stuck in charging	An object is preventing Automower®	Remove the object.
station	from reversing out of the charging
	station.

Upside down	Automower® leans too much or has	Turn the mower the right way up.
	turned over.

Needs manual	Automower® is set in MAN operating	This behaviour is normal; no action
charging	mode.	required.

Check ultrasonic	Debris, dust or similar has clogged	Clean the two ultrasonic sensors on
	the ultrasonic sensor.	the mower's body.

	Automower® has collided at too great	Place boundary wire around
	a speed a number of times.	obstacles not discovered by the
		ultrasonic.

English - 71

Image 71

Contents Husqvarna Automower 260 ACX OPERATOR’S Manual Page Table of Contents Table of Contents Introduction Introduction SafetySymbols on Automower Important Information Xxxxxx xxxxx xxxx xxxx xxxxx Symbols in the Operator’s ManualXxxxxx xxxxx xxxx xxxx xxxxx Use Safety instructionsTransport MaintenancePresentation Automower, what’s what? Mowing technique Function of AutomowerCapacity Working method Movement pattern Search method 1 Irregular Search method 2 Follow boundary wireSearch method 3 Follow guide wire Search methodGPS communication unit More than one Automower in a gardenOne Automower in several gardens Preparations InstallationCarry out the installation in the following steps Ideal position of the charging station Installation of the charging stationImportant Information Installation and connecting the charging station Do not tread or walk on the charging station plate Charging the batteryInstallation of the boundary wire Best position for the boundary wire Boundaries for the working area Boundaries within the working area Secondary areas Passages when mowingPassages when searching for the charging station Slopes Laying out the boundary wire Joining the boundary wire Laying the boundary wire in towards the charging stationConnecting the boundary wire Installation Linking Automower to the charging station Checking the installationNeed of a guide wire Installation of the guide wirePlacement and connection of the guide wire Maximum 135º Activate the GPS anti-theft Protection area Use Charging a discharged batterySMS feature Using the timerUsing GPS-communication GPS anti-theft protection Description CommandsRemarks Commands Stopping Automower Starting AutomowerRestart within 20 seconds Switching off AutomowerAdjusting the cutting height RestartControl panel Shortcuts Numbers Main switchSelect Number series Menu functionsMain menu Browse between menusAutomower Automower main menuTimer CommandsMon Tue Wed Thu Fri Sat Sun Run all Reset all timersYES Start time 1 Stop time 1 Start time 2 Stop time 2End angle 1 InstallationReversing distance Start angle 1When this function is activated Automower will To follow the boundary wire or a guide wire awayGardens where the front and back are joined by a Passage where the charging station cannot beFollow loop DirectionDistance ProportionCorridor width Test Test OUT Normal SettingsDrive past wire OpenTime lock4-1-2 PIN codeGPS Alarm4-1-3Date format Set timeSet date Time formatSound Significance SoundsGarden example Proposed installation and settingsExit angles Exit angles 250 Exit angles 70 Garden Example Battery MaintenanceCharging station ServiceWinter storage AutomowerChassis CleaningAfter winter storage Underframe and blade disc Body Replacing the bladesCarbon steel 522 85 Two-toothed, turnable, extra robust 300 Transport and movingFault messages Trouble shootingTrouble Shooting Fault symptom Data Automower 260 ACX Technical dataEU Declaration of Conformity only applies to Europe EU declaration of conformityPage Original Instructions

Related manuals

Manual 72 pages 54.36 Kb