flames or potential sources of ignition and air the room in which the appliance is standing for several minutes.
-- In order to avoid the creation of a flammable gas-air mixture if a leak in the refrigerating circuit occurs, the size of the room in which the appliance may be sited depends on the amount of refrigerant used.
-- Never start up an appliance showing any signs of damage. If in doubt, consult your dealer. The room where the refrigerator will be sited must be 1m³ in size for every 8g
of R-600a refrigerant inside the appliance. The amount of refrigerant in your particular appliance is shown on the identification plate inside the appliance.
-- If the appliance contains isobutane refrigerant (R-600a), a natural gas with high environmental compatibility that is, however, also combustible. When transporting and installing the appliance, care should be taken to ensure that no parts of the refrigerating circuit are damaged.
04_ Safety information
SEVERE WARNING WARNING SIGNS FOR
INSTALLATION
•Do not install this appliance in a humid, oily or dusty location, in a location exposed to direct sunlight and water (rain drops).
-- Deteriorated insulation of electrical parts may cause an electric shock or fire.
•Do not place this refrigerator in direct sunlight or expose to the heat from stoves, room heaters or other appliances.
•Do not plug several appliances into the same multiple power board.The refrigerator should always be plugged into its own individual electrical outlet which has a voltage rating that matched the rating plate.
-- This provides the best performance and also prevents overloading house wiring circuits, which could cause a fire hazard from overheated wires. If the wall socket is loose, do not insert the power plug.
-- There is a risk of electric shock or fire.• Do not use a cord that shows