A water dispenser with a filter is one of the helpful features on your new refrigerator. To help promote better health, the water filter removes unwanted particles from your water. However, it does not sterilize or destroy microorganisms. You may need to purchase a water purifying system to do that. In order for the ice maker to operate properly, a water pressure of 20~125 psi is required.
Under normal conditions, a 170 cc (5.75 oz.) cup can be filled in about 10 seconds.
If the refrigerator is installed in an area with low water pressure (below 20psi), you can install a booster pump to compensate for the low pressure.
After you have connected the water line, make sure the water storage tank inside the refrigerator is properly filled. To do this, press the water dispenser lever until the water runs from the water outlet.
Water line installation kits are include with unit. You can find it in freezer drawer.
The new
Parts for water line Installation
| up |
Water line fixer and screws | Pipe connector |
Water line | setting01 |
|
Connecting to the water supply line
1.First, shut off the main water supply line.
2.Locate the nearest cold, drinking water line.
3.Follow the Water line Installation Instructions in the installation kit.
CAUTION
The water line must be connected to the cold water pipe. If it is connected to the hot water pipe, it may cause the purifier to malfunction.
Close Main
Water pipe
Close Main | No gap |
Water pipe |
|
4.After connecting the water supply to the water filter, turn your main water supply back on and dispense about 3L to clear and prime the water filter.
setting up _21
2016. 3. 24. �� 8:20 |