Samsung SHR-5082P Callback Settings, Transfer Picture Settings, Web Viewer Port Setting, Use the, UP/DOWN, Static IP, Set it to, Port(UDP):, SETUP MENU, IP Address:, : Set it to

If you set up the public DDNS (dyndns. com, no-ip.com, or changeip.com), it will take approximately 30 to 60 seconds to get the IP address for the host name (URL) to be updated in the DNS.

To connect this product to an IP router, you have to designate a port for this product in the setup menu of the router. This product has 4 ports for TCP communication. To use the DHCP function provided by the IP router to allocate the dynamic IP to the product, designate a port for the IP that has been allocated by the IP router setup menu. When using the IP router, it

is recommended to use the fixed IP. For that purpose, set the IP address and port number to be allocated to the product, select Static IP in the connection mode and enter the IP address assigned to the IP router. For more information about using the IP router, see the user manual of the IP router or contact the manufacturer.

Callback Settings

This configuration is used to forward the callback messages to the IP where Smart Viewer is running. When any alarm, motion, or video loss events occur, the system automatically connects to the corresponding DVR to show the callback messages.

Callback Settings

On/Off	On
IP Address	192.168.001.010
Port(UDP)	7900
Retry	05
Transfer Alarm In	Off
Transfer Motion Detection	Off
Transfer Video Loss	Off
Transfer System Log	Off
		OK	Cancel

On/Off: Off is default. To use the callback function, choose On.

IP Address: Use the UP/DOWN direction buttons to set the TCP IP address of the PC where Smart Viewer is running.

Port(UDP): Use the UP/DOWN direction buttons to set a port number ranging from 7900 to 7999. The number changes by 1. You have to also set the port value in the Callback Connection menu for Smart Viewer setup.

Retry: Select a number ranging from 1 to 20. The number changes by 1.Transfer Alarm In: Set it to On to display alarms on Smart Viewer.

Transfer Motion Detection: Set it to On to display motion detection events on Smart Viewer.

Transfer Video Loss: Set it to On to display video loss events on Smart Viewer.

Transfer System Log: Set it to On to display system logs such as critical system failures.

Even if this function is set to On, any

CAUTION callback message will not be created unless the settings for alarm, motion

detection, and video loss are set in Event Record.To get the callback messages from Smart Viewer, click Callback.

Transfer Picture Settings

You can configure the video size and quality for transferring pictures.

Transfer Picture Settings

Video Size	CIF
Quality	Very High

OK Cancel

Video Size: Select any of CIF and Half D1.Quality: Select any of Very High, High, Standard, and Low.

Web Viewer Port Setting

You can configure the port number for Web Viewer.

Webviewer Port Setting

Port 080

OK Cancel

The available ports are those from 80 through 60080.

If you set the port number instead of 80(default), it is needed to type the port number into the address bar of the Web browser.

(e.g. http://218.209.27.130:500)menu setup _35

SETUP MENU 05