AMX NI-2100, NI-3100, NI-4100 manual

Contents

Main AMX Limited Warranty and Disclaimer Table of Contents Page Introduction battery levels are no longer acceptable. NI-2100 Specifications Page Page NI-3100 Specifications NI-3100 Specifications NI-3100 Specifications (Cont.) NI-4100 Specifications NI-4100 Specifications NI-4100 Specifications (Cont.) Page Page Installation and Upgrading Installing NetLinx Control Cards (NI-4100 Only) 6. 1. 2. 3. Setting the NetLinx Control Card Addresses (NI-4100 Only) (DIP switch address x 12) + Card slot Number (1-12) = Card address 1. 2. Device:Port:System (D:P:S) Removing NetLinx Control Cards (NI-4100 Only) 1. 2. 3. 4. 5. 6. Page Installing Into An Equipment Rack Page Connections and Wiring Setting the Configuration DIP Switch (for the Program Port) Baud Rate Settings Program Run Disable (PRD) Mode Working With the Configuration DIP Switch 1. Setting the CardFrame DIP Switch (NI-4100 Only) Program Port Connections and Wiring Modes and Front Panel LED Blink Patterns The Port Assignments are as follows: Port Assignments and Functionality Modes and LED Blink Patterns NI-2100 Port Assignments NI-3100/4100 Port Assignments AXlink Port and LED Wiring Guidelines Wiring length guidelines Preparing Captive Wires 1. 2. 3. Wiring a Power Connection 1. DB9 Device Port: Connections and Wiring ICSNet Port: Connections and Wiring RS-232/422/485 Device Port Wiring Specifications ICSNet RJ-45 Signals RJ-45 Pinout Information (EIA/TIA 568 B) ICSHub OUT Port: Connections and Wiring Relay Port: Connections and Wiring Relay Connections Input/Output (I/O) Port: Connections and Wiring IR/Serial Port: Connections and Wiring FIG. 20 shows the 20-pin (male) connector that provides connection to the NetLinx Control Cards. The IR/Serial connector wiring specifications are listed in the following table. NetLinx Control Card Slot Connector (NI-4100 only) IR/Serial Connector Wiring Specifications (per Port) Ethernet/RJ-45 Port: Connections and Wiring The following table lists the pinouts, signals, and pairing for the Ethernet connector. Ethernet LEDs FIG. 21 diagrams the RJ-45 pinouts and signals for the Ethernet RJ-45 connector and cable. Ethernet Ports Used By the Integrated Controller Ethernet Port Descriptions