Hardware Reference Guide
NI-x100 Series
NetLinx Integrated Controllers NI-2100, NI-3100, NI-4100
NetLinx Integrated Controllers
AMX Limited Warranty and Disclaimer
Installation and Upgrading
Table of Contents
Connections and Wiring
Introduction
IR/Serial Port Connections and Wiring
Input/Output I/O Port Connections and Wiring
NetLinx Control Card Slot Connector NI-4100 only
Ethernet/RJ-45 Port Connections and Wiring
NetLinx Integrated Master Controller Features
Introduction
NI-2100 Specifications
Introduction
NI-2100 Specifications
Note AMX may increase Flash size at any time in response to
Flash size provided
Settings
NI-2100 Specifications Cont
Introduction
Rear Panel Components Cont
FIG. 3 NI-3100 NetLinx Integrated Controller front view
NI-3100 Specifications
FIG. 4 NI-3100 front and rear panel connectors and components
Introduction
NI-3100 Specifications
Front Panel LEDs
Rear Panel Components
Settings
NI-3100 Specifications Cont
Introduction
Rear Panel Components Cont
8 IR/Serial Output ports, 8 Digital Input/Output ports, and 8 Relays
NI-4100 Specifications
Introduction
Front
Introduction
NI-4100 Specifications
Front Panel LEDs/Slots
Rear Panel Components
Settings
NI-4100 Specifications Cont
Introduction
Rear Panel Components Cont
NI-2100, NI-3100, NI-4100 Hardware Reference Guide
Related Documents
Introduction
NI-2100, NI-3100, NI-4100 Hardware Reference Guide
Introduction
Installing NetLinx Control Cards NI-4100 Only
Installation and Upgrading
DevicePortSystem DPS
Setting the NetLinx Control Card Addresses NI-4100 Only
Removing NetLinx Control Cards NI-4100 Only
Compact Flash Upgrades
Accessing The Internal Components On An Integrated Controller
The NI-4100 has six screws on top and four on each side
5. Remove the upgrade card from it’s anti-static bag
Installation of Compact Flash Upgrades
Closing and Securing the Outer Housing
Installing Into An Equipment Rack
7. Apply power to the unit to complete the installation
Setting the Configuration DIP Switch for the Program Port
Connections and Wiring
Baud Rate Settings
Program Run Disable PRD Mode
Working With the Configuration DIP Switch
Setting the CardFrame DIP Switch NI-4100 Only
Program Port Connections and Wiring
Port Assignments and Functionality
Modes and Front Panel LED Blink Patterns
Connections and Wiring
Modes and LED Blink Patterns
AXlink Port and LED
Wiring Guidelines
Wiring length guidelines
1 blink per second - Normal operation
1. Strip 0.25 inch 6.35 mm of insulation off all wires
Preparing Captive Wires
Wiring a Power Connection
Using the 4-Pin Mini-Phoenix Connector For Data and Power
Using the 4-pin Mini-Phoenix Connector For Data With External Power
DB9 Device Port Connections and Wiring
RS-232/422/485 Device Port Wiring Specifications
ICSNet Port Connections and Wiring
ICSNet RJ-45 Signals
Connections and Wiring
Relay Connections
ICSHub OUT Port Connections and Wiring
Relay Port Connections and Wiring
Input/Output I/O Port Connections and Wiring
NetLinx Control Card Slot Connector NI-4100 only
IR/Serial Port Connections and Wiring
Ethernet LEDs
Ethernet/RJ-45 Port Connections and Wiring
Ethernet Ports Used By the Integrated Controller
Connections and Wiring
Ethernet Port Descriptions
Port type
NI-2100, NI-3100, NI-4100 Hardware Reference Guide
Connections and Wiring
It’s Your World - Take Control