NetLinx Integrated Controllers
NI-x100 Series
Hardware Reference Guide
NetLinx Integrated Controllers NI-2100, NI-3100, NI-4100
AMX Limited Warranty and Disclaimer
Introduction
Table of Contents
Installation and Upgrading
Connections and Wiring
Ethernet/RJ-45 Port Connections and Wiring
Input/Output I/O Port Connections and Wiring
IR/Serial Port Connections and Wiring
NetLinx Control Card Slot Connector NI-4100 only
NetLinx Integrated Master Controller Features
Introduction
NI-2100 Specifications
Flash size provided
NI-2100 Specifications
Introduction
Note AMX may increase Flash size at any time in response to
Rear Panel Components Cont
NI-2100 Specifications Cont
Settings
Introduction
NI-3100 Specifications
FIG. 4 NI-3100 front and rear panel connectors and components
FIG. 3 NI-3100 NetLinx Integrated Controller front view
Rear Panel Components
NI-3100 Specifications
Introduction
Front Panel LEDs
Rear Panel Components Cont
NI-3100 Specifications Cont
Settings
Introduction
Front
NI-4100 Specifications
8 IR/Serial Output ports, 8 Digital Input/Output ports, and 8 Relays
Introduction
Rear Panel Components
NI-4100 Specifications
Introduction
Front Panel LEDs/Slots
Rear Panel Components Cont
NI-4100 Specifications Cont
Settings
Introduction
Related Documents
Introduction
NI-2100, NI-3100, NI-4100 Hardware Reference Guide
NI-2100, NI-3100, NI-4100 Hardware Reference Guide
Introduction
Installing NetLinx Control Cards NI-4100 Only
Installation and Upgrading
DevicePortSystem DPS
Setting the NetLinx Control Card Addresses NI-4100 Only
The NI-4100 has six screws on top and four on each side
Compact Flash Upgrades
Removing NetLinx Control Cards NI-4100 Only
Accessing The Internal Components On An Integrated Controller
5. Remove the upgrade card from it’s anti-static bag
Installation of Compact Flash Upgrades
Closing and Securing the Outer Housing
Installing Into An Equipment Rack
7. Apply power to the unit to complete the installation
Program Run Disable PRD Mode
Connections and Wiring
Setting the Configuration DIP Switch for the Program Port
Baud Rate Settings
Setting the CardFrame DIP Switch NI-4100 Only
Program Port Connections and Wiring
Working With the Configuration DIP Switch
Modes and LED Blink Patterns
Modes and Front Panel LED Blink Patterns
Port Assignments and Functionality
Connections and Wiring
1 blink per second - Normal operation
Wiring Guidelines
AXlink Port and LED
Wiring length guidelines
Using the 4-Pin Mini-Phoenix Connector For Data and Power
Preparing Captive Wires
1. Strip 0.25 inch 6.35 mm of insulation off all wires
Wiring a Power Connection
Using the 4-pin Mini-Phoenix Connector For Data With External Power
DB9 Device Port Connections and Wiring
Connections and Wiring
ICSNet Port Connections and Wiring
RS-232/422/485 Device Port Wiring Specifications
ICSNet RJ-45 Signals
ICSHub OUT Port Connections and Wiring
Relay Port Connections and Wiring
Relay Connections
Input/Output I/O Port Connections and Wiring
NetLinx Control Card Slot Connector NI-4100 only
IR/Serial Port Connections and Wiring
Ethernet LEDs
Ethernet/RJ-45 Port Connections and Wiring
Port type
Connections and Wiring
Ethernet Ports Used By the Integrated Controller
Ethernet Port Descriptions
NI-2100, NI-3100, NI-4100 Hardware Reference Guide
Connections and Wiring
It’s Your World - Take Control