NI-x100 Series
Hardware Reference Guide
NetLinx Integrated Controllers NI-2100, NI-3100, NI-4100
NetLinx Integrated Controllers
AMX Limited Warranty and Disclaimer
Table of Contents
Installation and Upgrading
Connections and Wiring
Introduction
Input/Output I/O Port Connections and Wiring
IR/Serial Port Connections and Wiring
NetLinx Control Card Slot Connector NI-4100 only
Ethernet/RJ-45 Port Connections and Wiring
Introduction
NetLinx Integrated Master Controller Features
NI-2100 Specifications
NI-2100 Specifications
Introduction
Note AMX may increase Flash size at any time in response to
Flash size provided
NI-2100 Specifications Cont
Settings
Introduction
Rear Panel Components Cont
NI-3100 Specifications
FIG. 4 NI-3100 front and rear panel connectors and components
FIG. 3 NI-3100 NetLinx Integrated Controller front view
NI-3100 Specifications
Introduction
Front Panel LEDs
Rear Panel Components
NI-3100 Specifications Cont
Settings
Introduction
Rear Panel Components Cont
NI-4100 Specifications
8 IR/Serial Output ports, 8 Digital Input/Output ports, and 8 Relays
Introduction
Front
NI-4100 Specifications
Introduction
Front Panel LEDs/Slots
Rear Panel Components
NI-4100 Specifications Cont
Settings
Introduction
Rear Panel Components Cont
Related Documents
Introduction
NI-2100, NI-3100, NI-4100 Hardware Reference Guide
Introduction
NI-2100, NI-3100, NI-4100 Hardware Reference Guide
Installation and Upgrading
Installing NetLinx Control Cards NI-4100 Only
Setting the NetLinx Control Card Addresses NI-4100 Only
DevicePortSystem DPS
Compact Flash Upgrades
Removing NetLinx Control Cards NI-4100 Only
Accessing The Internal Components On An Integrated Controller
The NI-4100 has six screws on top and four on each side
Installation of Compact Flash Upgrades
5. Remove the upgrade card from it’s anti-static bag
Installing Into An Equipment Rack
Closing and Securing the Outer Housing
7. Apply power to the unit to complete the installation
Connections and Wiring
Setting the Configuration DIP Switch for the Program Port
Baud Rate Settings
Program Run Disable PRD Mode
Setting the CardFrame DIP Switch NI-4100 Only
Program Port Connections and Wiring
Working With the Configuration DIP Switch
Modes and Front Panel LED Blink Patterns
Port Assignments and Functionality
Connections and Wiring
Modes and LED Blink Patterns
Wiring Guidelines
AXlink Port and LED
Wiring length guidelines
1 blink per second - Normal operation
Preparing Captive Wires
1. Strip 0.25 inch 6.35 mm of insulation off all wires
Wiring a Power Connection
Using the 4-Pin Mini-Phoenix Connector For Data and Power
DB9 Device Port Connections and Wiring
Using the 4-pin Mini-Phoenix Connector For Data With External Power
ICSNet Port Connections and Wiring
RS-232/422/485 Device Port Wiring Specifications
ICSNet RJ-45 Signals
Connections and Wiring
ICSHub OUT Port Connections and Wiring
Relay Port Connections and Wiring
Relay Connections
Input/Output I/O Port Connections and Wiring
IR/Serial Port Connections and Wiring
NetLinx Control Card Slot Connector NI-4100 only
Ethernet/RJ-45 Port Connections and Wiring
Ethernet LEDs
Connections and Wiring
Ethernet Ports Used By the Integrated Controller
Ethernet Port Descriptions
Port type
Connections and Wiring
NI-2100, NI-3100, NI-4100 Hardware Reference Guide
It’s Your World - Take Control
