Installation and Upgrading
NUMBER:PORT:SYSTEM
where:
NUMBER: | |
PORT: | |
| ports on the Controller or device) |
SYSTEM: |
Removing NetLinx Control Cards (NI-4100 Only)
To install NetLinx Control Card:
1.Discharge any static electricity from your body, by touching a grounded object and unplug all connectors (if any) from the unit.
2.Remove the three faceplate screws by turning them in a
3.Remove the faceplate from the front plate (FIG. 7 on page 13).
4.Gently grasp the rear edge of the control card and gently pull it out from the unit (along the internal guide slots).
5.
6.
Compact Flash Upgrades
The NetLinx Integrated Controllers are shipped with a default 32 MB Compact Flash module.
It is recommended that ANY MEMORY UPGRADE should be done prior to any installation. Refer to the following accessing and installation sections for more information.
The Compact Flash card is factory programmed with specific Controller firmware. These cards can be ordered from AMX in several different upgrade sizes (see the following table):
Optional Compact Flash Upgrades
Product Name | Description |
|
|
64 MB compact flash card | |
|
|
128 MB compact flash card | |
|
|
256 MB compact flash card | |
|
|
512 MB compact flash card | |
|
|
1 GB compact flash card | |
|
|
Accessing The Internal Components On An Integrated Controller
1.Carefully detach all connectors from the rear of the unit.
2.Remove the chassis housing screws from both the sides and top of the Controller, as shown in FIG. 9 by using a grounded screwdriver turning in a
The
The NI-4100 has six screws on top and four on each side.
15 | |
|
|
