AMX NI-2100 manual NI-3100 Specifications Cont, Introduction, Rear Panel Components Cont, Settings

Introduction

NI-3100 Specifications (Cont.)

Rear Panel Components (Cont.):

•IR/Serial (Ports 9 - 16): 8 IR/Serial control ports support high-frequency carriers of up to 1.142 MHz with each output being capable of two electrical formats: IR or Serial.

•8 IR/Serial data signals can be generated simultaneously.

•IR ports support data mode (at limited baud rates and wiring distances).

• Program Port:	RS-232 DB9 connector (male) can be connected to a DB9 port on a PC. This
	connector can be used with serial and NetLinx programming commands, as
	well as other DB9 capable devices, to both upload/download information from
	the NetLinx Studio program.
• Configuration DIP	Sets the communication parameters for the Program port (see Baud Rate
Switch:	Settings).
• ID Pushbutton:	Sets the NetLinx ID (Device only) assignment for the device.
• Ethernet Port:	RJ-45 connector provides TCP/IP communication. This is an Auto MDI/MDI-X
	enabled port, which allows you to use either straight-through or crossover
	Ethernet cables.
	The Ethernet Port LEDs show communication activity, connection status,
	speeds, and mode information:
	• SPD (speed) - Yellow LED lights On when the connection speed is 100
	Mbps and turns Off when the speed is 10 Mbps.
	• L/A (link/activity) - Green LED lights On when the Ethernet cables are
	connected and terminated correctly, and blinks when receiving Ethernet
	data packets.
• AxLink Port:	4-pin 3.5 mm mini-Phoenix (male) connector that provides data and power to
	external control devices. Green AXlink LED indicates the state of the AXlink
	port.
• Power Port:	2-pin 3.5 mm mini-Phoenix (male) connector.
Included Accessories:	• 2-pin 3.5 mm mini-Phoenix (female) PWR connector (41-5025)
	• 4-pin 3.5 mm mini-Phoenix (female) AXlink connector (41-5047)
	• 10-pin 3.5 mm mini-Phoenix (female) I/O connector (41-5107)
	• Installation Kit (KA2105-01):
	- 8-pin Relay Common Strip
	- 4 rack mount screws
	- 4 washers
	• 2 8-pin 3.5 mm mini-Phoenix female Relay connectors (41-5083)
	• 2 CC-NIRC NetLinx IR Emitter Cables (FG10-000-11)
	• 2 removable rack ears (62-2105-07)
Other AMX Equipment:	• 2-pin 3.5 mm mini-Phoenix male connector (41-5026)
	• CSB Cable Support Bracket (FG517)
	• CC-NSER IR/Serial cables (FG10-007-10)
	• ICSNet daughter card (FG2105-10)
	• NCK, NetLinx Connector Kit (FG2902)
	• STS, Serial To Screw Terminal (FG959)
	• Upgrade Compact Flash (factory programmed with firmware):
	NXA-CF2NI256M - 256 MB compact flash card (FG2116-47)
	NXA-CF2NI512M - 512 MB compact flash card (FG2116-48)
	NXA-CF2NI1G - 1 GB compact flash card (FG2116-49)

NI-2100, NI-3100, NI-4100 Hardware Reference Guide 7