Introduction
NI-2100 Specifications (Cont.)
Rear Panel Components (Cont.):
• IR/Serial | 4 IR/Serial control ports support |
(Ports 5 - 8): | with each output being capable of two electrical formats: IR or Serial. |
| • 4 IR/Serial data signals can be generated simultaneously. |
| • IR ports support data mode (at limited baud rates and wiring distances). |
|
|
• Program Port: | |
| connector can be used with serial and NetLinx programming commands, as |
| well as other DB9 capable devices, to both upload/download information from |
| the NetLinx Studio program. |
|
|
• Configuration DIPSwitch: | Sets the communication parameters for the Program port (see Baud Rate |
| Settings). |
|
|
• ID Pushbutton: | Sets the NetLinx ID (Device only) assignment for the device. |
|
|
• Ethernet Port: | |
| X enabled port, which allows you to use either |
| Ethernet cables. |
| The Ethernet Port LEDs show communication activity, connection status, |
| speeds, and mode information: |
| • SPD (speed) - Yellow LED lights On when the connection speed is 100 |
| Mbps and turns Off when the speed is 10 Mbps. |
| • L/A (link/activity) - Green LED lights On when the Ethernet cables are |
| connected and terminated correctly, and blinks when receiving Ethernet |
| data packets. |
|
|
• AxLink Port: | |
| external control devices. Green AXlink LED indicates the state of the AXlink |
| port. |
|
|
• Power Port: | |
|
|
Included Accessories: | • |
| • |
| • |
| • |
| • Installation Kit |
| - |
| - 4 rack mount screws |
| - 4 washers |
| • 2 |
| • 2 removable rack ears |
|
|
Other AMX Equipment: | • |
| • CSB Cable Support Bracket (FG517) |
| • |
| • |
| • ICSNet daughter card |
| • NCK, NetLinx Connector Kit (FG2902) |
| • STS, Serial To Screw Terminal (FG959) |
| • Upgrade Compact Flash (factory programmed with firmware): |
| |
| |
| |
|
|
4 |