Black Box COMPACT T1 quick start

Contents

Main Compact T1 QUICK START GUIDE Page P Safety Information CAUTION! Preface Electrostatic Discharge (ESD) Precautions WARNING! Q UICK S In this Guide Unpacking and Inspection WARNING! Installation Environment Assembly of Compact T1 Wall Mounting NOTE: Rack Mounting (Optional Feature) Page Page NOTE: Quick Start Compliant Installation Signal Cables NOTE: Power Cables Ferrite Beads Ferrite Beads shipped with Adit chassis: Service Card Cables that Require Additional Ferrite Beads: Chassis Connectors and Buttons Interface Connectors Chassis Ground Connector Quick Start Power Reset Power Connections AC Power -48V Battery WARNING! Page External Alarm Connector 25-Pair Telco Connectors Pair Pin Location Function Color Code RS-232 Craft Port (Female DB-9) Quick Start T1 Connection Ports Ethernet (RJ-45) T1 (RJ-48C) 10Base-T Ethernet Local and Remote Management Option Setting up a CLI connection Configuration Initial Setup Set Up Security Set Up a DS1/T1 Set Up a DS0/Channel Set Up an Analog Port Use the following commands to set up an analog port. Set Up the Router (IP or CMG) Cards Establish a Static Channel Connection Use the following commands to establish a static channel connection. Set Up a ISDN BRI Service Use the following commands to set up a IS DN BRI Service. See the set (bri) command for details. Set Up the OCU-DP Card The following is a basic setup for the OCU-DP card. Set Up a V.35 Port Change the IP Address of the DS0 Management Channel Upgrade the Controller Software Upgrade the Router (IP or CMG) Software Install Country Specific Ringer Tones 30 Compact T1 - Release 6.1 Controller Cards Controller Cards T1 Controller Card Dip Switches Switch Function Description Page Power Supplies 115 VAC/-48 VDC Power Supply The power supply card has two LEDs, as described in the table below. Compact T1 - Release 6.1 33 Quick Start Service Cards Each port on the FXO card has its own LED, as described in the table below FXO Card DIP Switch Settings Switch Function Description Note FXS Card DIP Switch Settings Each port on the FXS card has its own LED, as described in the table below. FXS and FXS5G card Compact T1 - Release 6.1 35 ISDN BRI Card There is an LED for each ISDN BRI on a card, as described in the table belo w : OCU-DP Card There are two LEDs for each channel on the OCU-DP card. The function for each LED is listed below: 36 Compact T1 - Release 6.1 Quad T1 Card Each V.35 port has its own LED, as shown in the table below. V.35/V.54 Card CMG Router Card The following chart describes each LED, and its state, of the CMG Router card. IP Router Card The following chart describes each LED, and its state, of the Rout er card