2Quick Installation Guide
Installing the System
Determine Site Requirements
To install the system in your network, follow the steps in this section.
WARNING: For safety reasons and to ensure adequate cooling airflow, install blank faceplates over all empty slots.
Install the system in an area that meets the requirements in Table 1.
1Table 1 System Site Requirements
Location
■Ambient (room) temperature — 0 to 50 °C (32 to 122 °F) at sea level
■Operating humidity — 10% to 90% relative humidity, noncondensing
■Storage humidity — 10% to 95% relative humidity, noncondensing
■A level surface for system installation
Power
■Heat dissipation — 362 Watts
■Power source location — Power source within approximately 1.8 meters (6 feet)
■Input voltage options — 90 VAC to 264 VAC
■Current rating — 100 VAC at 3.8 amperes (maximum); 240 VAC at 1.5 amperes (maximum)
Unpack the System
2
For more information, see Appendix A “System Specifications” and Appendix C “Site Requirements and Safety Codes” in the Getting Started Guide.
Check the packing slip to verify that you have all components.
The system is shipped with one system processor module and one power supply installed. If you have ordered a second power supply for the system, be sure that it is available for installation.
