System Administrator’s Guide U42252-J-Z915-1-76

4 Installation and Configuration
The following chapter describes the installation and configuration of NSR-ORA.

4.1 Quick Start

This section gives experienced users an short overview of all steps required to
install and configure NSR-ORA. It is a synopsis of the information presented in
this chapter and the rest of the manual and is intended to help you to get NSR-
ORA “up and running” quickly and easily.
In order to install NSR-ORA and prepare it for use you need to carry out the
following steps:
1. Install NSR-ORA on the database computer (Enabler and NSR-ORA pack-
age) using the relevant command for the respective platform. Refer to the
sections “Licensing NSR-ORA” and “Installing NSR-ORA from CD”.
2. Now start the database (with startup or, in the case of OPS, with startup
parallel) so that configure_nsrora can determine the tablespace names.
3. Call up the configure_networker tool and fill in the informations described in
section “Parameters for configure_nsrora”.
4. Make sure that you have NSR administrator rights.
5. Call up the configure_networker tool (refer also to the section “Configuring
NetWorker”).
When using a NetApp filer in order to perform NDMP-backups, you may
have to define some NetWorker ressources manually (see “Configuring Net-
Worker”).
6. Specify the Start time for the database group in NetWorker and set the
attribute Autostart to Enabled (for further information, please refer to your
NetWorker documentation).
7. Highlight the required data carriers for the database and the archiving
monitor amon (see the manual NetWorker - Installing, Configuring and
Operating).
8. Make sure that the database is in the archive mode using the command
archive log list.