System Administrator’s Guide U42252-J-Z915-1-76
Installation and Configuration NSR-ORA in OPS clusters
They will be used to configure your NetWorker Server.
Please press ENTER to continue
created resource id 0.20.3.237.51.225.160.62.77.0.0.4(1)
created resource id 0.21.3.237.51.225.160.62.77.0.0.4(1)
created resource id 0.22.3.237.51.225.160.62.77.0.0.4(1)
created resource id 0.23.3.237.51.225.160.62.77.0.0.4(1)
created resource id 0.24.3.237.51.225.160.62.77.0.0.4(1)
created resource id 0.25.3.237.51.225.160.62.77.0.0.4(1)
created resource id 0.26.3.237.51.225.160.62.77.0.0.4(1)
created resource id 0.27.3.237.51.225.160.62.77.0.0.4(1)
created resource id 0.28.3.237.51.225.160.62.77.0.0.4(1)
Please NOTE:
- The Group backup_ORA2_nero is disabled now. Please enable it and
choose the start time.
created resource id 0.29.3.237.51.225.160.62.77.0.0.4(1)
created resource id 0.30.3.237.51.225.160.62.77.0.0.4(1)
created resource id 0.31.3.237.51.225.160.62.77.0.0.4(1)
4.4 NSR-ORA in OPS clusters
This section describes points to observe during installation and configuration of
NSR-ORA in an OPS cluster (ORACLE Parallel Server cluster).

4.4.1 Installation

Installing NSR-ORA on all the OPS nodes as described in the
section “Installation“.
For OPS systems the archiving monitor amon is used on every OPS
node, so we recommend to use the same pathname for the redolog files
on every node.

4.4.2 Configuration

Special attention must be paid to the following factors when installing NSR-ORA
in OPS systems:
●NSR-ORA is configured from just one of the OPS nodes. The following
commands have to be executed one after the other on that node
# configure_nsrora
...
# configure_networker
i