4.Press Clear All [SK] to delete all stored depth information.
−−The operator may select the memory location to store the depth readings by pressing Mem Select [SK]. When the preferred location appears on the screen, press Save [SK]. The screen and memory location will populate with the current information.
−−Each memory location can be reviewed by pressing Mem Select [SK].
5.Press Locate [5] to return to Locate Mode.
Frequencies
Active
Active frequencies are trace signals supplied by a 3M™ Dynatel™ Transmitter 2200 Series (577 Hz, 8 KHz, 33 KHz, or 133 KHz).
1.Select the same frequency that the transmitter is generating;
2.Press Locate [5]
3.Press Cable/Pipe [SK]
4.Press Freq [SK]
5.Press ACTIVE [SK Toggle] until the desired frequency is displayed in the soft key command [9] (“Active” 577, 8K, 33K or 133K)
6.Press Locate [5] to return to Locate mode.
Power
Power frequencies refer to 50 or 60 Hz signals, and their harmonics that can be traced without the use of a transmitter.
50:Best for general locating of passive power.
50H (high harmonic): If the 50 choice appears to be responding slowly, or poorly, then 50H is the second choice for locating of passive power.
50L (low harmonic): Third choice for passive power locating. May be used when 50 or 50L is weak or erratic.
100 Hz: Used for locating rectified AC power signals, often found on pipelines using impressed current cathodic protection.
1.Press Locate [5]
2.Press Cable/Pipe [SK]
3.Press Freq [SK]
21 |
