3M 2273ME-iD, 2250ME-iD manual Depth of Passive, Non-iD Marker

Depth of Passive, Non-iD Marker

1.Lower the tip of the receiver to the ground over the targeted marker.

2.Press Depth [SK].

−−The receiver will examine the targeted marker.

−−The screen will instruct the operator to raise the unit 15.2 cm (6 inches) from the ground.

Note: This 15.2 cm (6-inch) rise must be exact for the depth reading to be accurate.

3.Raise the unit 15.2 cm (6 inches). Press Depth [SK] key again. The estimated depth of the marker from ground level will display on the screen.

−−Five depth readings can be saved with the time, and date.

4.To access the memory locations, press Mem Select [SK].

−−Save [SK] will place each entry in sequential order in memory (M1–M5) until five readings have been stored. The unit will overwrite saved entries in excess of five, beginning with M1.

5.Press Clear All [SK] to delete all stored depth information.

6.Press Mem Select [SK] to select the memory location to store the depth readings. When the preferred location appears on the screen, press Save [SK]. The screen and memory location will populate with the current information.

7.Each memory location can be reviewed by pressing Mem Select [SK Toggle].

8.Press Locate [5] to return to Marker Locate Mode.

32 78-8130-6151-8-E