Section 7: Troubleshooting

Symptoms/Solutions

Symptom

Cause

Solution

 

 

 

Power cannot be

• MAIN POWER switch is not turned on.

• Turn the MAIN POWER switch on.

turned on.

• The power cord is disconnected.

• Insert the power cord into an AC socket.

 

• 60 seconds have not elapsed since

• Wait 60 seconds before turning on power.

 

the power was turned off.

 

 

 

 

No picture or sound.

• The setting of the input source is not

• Set the correct input using the input select button of

 

correct.

the projector or the remote control.

 

• RGB/Video/Audio wiring to projector is

• Connect the cable to correct input/output source.

 

not correct.

 

 

 

 

Sound is heard without

• RGB/Video/Audio wiring to projector

• Connect the cable to correct input/output source.

picture.

is not correct.

 

 

• The brightness is set fully to dark.

• Press the MENU button and increase BRIGHTNESS.

 

• Lens cap is on.

• Remove lens cap.

 

 

 

Picture is displayed

• Audio wiring to projector is not correct.

• Connect the cable to correct input/output source.

without sound.

• The volume is set to minimum.

• Press the VOL button to increase Volume.

 

• The volume is muted.

• Press the MUTE button.

 

 

 

Color is weak and tint is

• The color and tint have been adjusted

• Adjust the color and tint correctly.

incorrect.

incorrectly.

 

 

 

 

Picture is dark.

• The brightness and contrast has not

• Adjust the brightness and contrast correctly.

 

been adjusted correctly.

 

 

• The lamp needs to be replaced.

• Replace the lamp with a new one.

 

 

 

Picture is not clear.

• Projector is out of focus.

• Adjust the focus and H. PHASE.

 

 

 

LAMP indicator lights

• Lamp will not ignite.

• Turn off power and let cool for 20 minutes, then restart.

red.

 

• If problem persists call your dealer.

 

• Temperature inside projector is too hot.

• Check and clear blocked ventilation holes.

 

 

• Check and clean air filter.

 

 

 

LAMP indicator blinks

• Lamp access door on bottom of case

• Ensure lamp access door is closed.

red.

is open.

 

 

• The lamp usage has reached

• Replace the lamp.

 

maximun operating hours.

 

 

 

 

TEMP indicator blinks

• Cooling fan not operating.

• Contact your dealer.

red.

 

 

 

 

 

© 3M IPC 2000

3MPersonal Projector MP8746/MP8747

27

 

 

 

Page 27
Image 27
3M MP8746, MP8747 manual Troubleshooting, Symptoms/Solutions