Section 6: Lamp
Replacing the Lamp
|
| WARNING | To reduce the risk of electrical shock, always turn off projector and disconnect |
|
| ||
|
| power cord before changing lamp. | |
|
|
| |
|
|
|
|
✔Note: For maximum lamp life, do not shock, handle or scratch the lamp glass when it is hot. Do not use an old or previously used lamp as a replacement lamp.
1.Remove lamp access door: The lamp access door is located on the bottom of the machine. Use a flat- head screwdriver to remove the two screws from the lamp access door. Lift off the lamp access door and set it aside.
2.Use the screwdriver to remove the lamp module retaining screws.
✔Note: These screws are
3.Remove lamp module: Carefully slide the lamp module out by pulling straight up on the retaining wire on top of the module.
4.Insert lamp module: Carefully insert the new lamp module by sliding it straight down into the opening. Ensure that it is fully seated. Reinsert and tighten the lamp module retaining screws to secure the lamp module in place.
5.Insert the hinge tabs on the bottom of the lamp access door, and close. Reinsert and tighten the two screws to secure the lamp access door.
✔ Note: Reset the lamp operation hours. See the previous page for details. |
Lamp Access Door | Lamp Module | Retaining |
Retaining Screws | Retaining Screws | Wire |
Figure 6.1 Changing Lamp Module
Caution | This lamp contains mercury. Consult your local hazardous waste regulations and | |
dispose of this lamp in the proper manner. | ||
| ||
|
|
26 | 3M™ Personal Projector MP8746/MP8747 | © 3M IPC 2000 |
|
|
|
