Abit NI8 SLI user manual Power Management Setup, ACPI Suspend Type, Resume by USB From S3

BIOS Setup 3-23

3-6. Power Management Setup

Phoenix – AwardBIOS CMOS Setup Utility

Power Management Setup

ACPI Suspend Type	S3(Suspend-to-RAM	Item Help
X - Resume by USB From S3	Disabled
Power Button Function	Instant-Off
Wake-Up by PME# of PCI	Disabled
Resume by Ring	Disabled
Power-On by Alarm	Disabled
X - Date of Month Alarm	0
X - Time (hh:mm:ss) Alarm	0 : 0 : 0
POWER ON Function	BUTTON ONLY
X - KB Power ON Password	Enter
X - Hot Key Power ON	Ctrl-F1
Restore on AC Power Loss	Power Off

↑↓:Move Enter:Select +/-/PU/PD:Value F10:Save ESC:Exit F1:General Help F5: Previous Values F6: Fail-Safe Defaults F7: Optimized Defaults

ACPI Suspend Type:

This item selects the type of Suspend mode.

[S1(PowerOn-Suspend)]:Enables the Power On Suspend function.

[S3(Suspend-To-RAM)]:Enables the Suspend to RAM function.

!Resume by USB From S3:

When set to [Enabled], this item allows you to use a USB device to wake up a system that is in the S3 (STR - Suspend To RAM) state. This item can be configured only if the item “ACPI Suspend Type” is set to [S3(STR)].

NOTE: To enable this “Resume by USB From S3” function, the wake-up header of [USB-PWR1], [USB-PWR2], [USB-PWR3], [USB-PWR4] and [USB-PWR5] must be set to [Enabled] position. Please refer to the configuration of “Wake-up Header” in section 2-4, chapter 2.

Power Button Function:

This item selects the method of powering off your system:

[Delay 4 Sec.]: Pushing the power button for more than 4 seconds will power off the system. This will prevent the system from powering off in case you accidentally hit or pushed the power button.

[Instant-Off]:Pressing and then releasing the power button at once will immediately power off the system.

Wake-Up by PME# of PCI:

When set to [Enabled], access to the onboard LAN or a PCI card such as a modem or LAN card will cause the system to wake up. The PCI card must support the wake up function.

User’s Manual