Hardware Setup | |
|
|
Please follow the instructions below to set the system to SLI mode and install your graphics cards.
NOTE: Please handle the switchboard with caution. Watch out for the sharp edges.
1.Simultaneously push the two retention clips at both ends outward to release the switchboard. Carefully pull the switchboard out of the slot.
2.Flip the switchboard over to the side labeled with “SLI”. Carefully insert the switchboard into the slot.
3.Slightly push down the switchboard until the retention clip snap into places. Make sure the switchboard is completely inserted into the slot.
4.Insert the two graphics cards into PCIEXP1 and PCIEXP2 slots on the motherboard.
5.There are goldfingers on your SLI Graphics Cards reserved for the SLI Bridge Connector.
