LCD Screen Indicators

Indicators appear at the top and bottom of the LCD screen to indicate the status of the camera and the results of adjustments.

MAG

BATT

Indicator section

SAVE

1MAG indicator

2Magnification section indicator

3Red tally/recording indicator

4 BATT indicator

Image

5Green tally indicator

6 SAVE indicator

5Green tally indicator

7 indicator

1MAG (magnification) indicator

Lights when the MAG button (see page 5 (E)) on the front panel has been pressed to select magnified display.

2Magnification section indicator

Shows which section of the screen is being magnified: upper left (), upper right (), lower right (), lower left (), or center().

3Red tally/recording indicator

Lights in red or flashes, to indicate the following. Lit: Recording, or reception of a tally signal from a

camera control unit.

Flashing: The VTR attached to the camera is not servo-locked.

For details, refer to the manual supplied with your camera.

4BATT (battery) indicator

Lights or flashes to indicate the state of the battery. Lit: Battery power is exhausted.

Flashing: The battery is low on power.

To avoid interruptions while operating the camera, you should exchange the battery as soon as possible after this indicator flashes.

The voltage level at which this indicator starts flashing can be specified on the camera side. For details, refer to the manual supplied with your camera.

5Green tally indicator

Lights up when the camera receives a green tally control signal from the camera control unit.

6SAVE (VTR save) indicator

Lights when the VTR attached to the camera is in power save mode.

7 (alarm) indicator

Lights when the camera is in an alarm state. The conditions under which this indicator lights can be specified on the camera side.

For details, refer to the manual supplied with your camera.

13(E)