Accusys eXpeRAID manual Example CLICtrlName Ctrl1 Enter

					ACCUSYS, INC.
				5F, 38 TAIYUAN ST, JHUBEI, HSINCHU, TAIWAN, R.O.C.
	TITLE	EXPERAID COMMAND LINE INTERFACE USER GUIDE
	PROJECT		“DESKTOP RAID”		DOCUMENT STATUS	OFFICIAL RELEASE
	REV.	G–05-NOV-2007				PAGE 13 OF 27
3.3.1.4
Command Name				Command Description
SetPassword				Use this command to set password of the active controller.
Parameter 1				Parameter Description
Password:				Password:
<CHARS>				CHARS must be an 8-character alphabetic string.
3.3.1.5
Command Name				Command Description
CtrlName				Use this command to set controller name of the active controller.
Parameter 1				Parameter Description
Controller Name:				Controller Name:
<CHARS>				CHARS may not exceed 16 characters.
				Example
				CLI>CtrlName Ctrl1 [Enter]
				The controller name will be set to ‘Ctrl1’. If the number of characters
				in parameter 1 is more than 16, the additional characters will be
				ignored.
3.3.1.6
Command Name				Command Description
RunScript				Use this command to run CLI commands from a pre-written script file.
Parameter 1				Parameter Description
File Path:				File Path:
<[DIR] <FileName>>				Specify an existing script file(FileName) located in the specified
				directory.
				Example(Under Linux environment)
				CLI> RunScript /tmp/script1 [Enter]
				CLI will start to run commands written in the script file ‘script1’
3.3.1.7
Command Name				Command Description
Exit				Use this command to quit CLI command line interface.
				Parameter Description
				N/A