Accusys eXpeRAID manual Example CLIRebuildParity Array=1 State=Start Enter

					ACCUSYS, INC.
				5F, 38 TAIYUAN ST, JHUBEI, HSINCHU, TAIWAN, R.O.C.
	TITLE	EXPERAID COMMAND LINE INTERFACE USER GUIDE
	PROJECT		“DESKTOP RAID”		DOCUMENT STATUS	OFFICIAL RELEASE
	REV.	G–05-NOV-2007				PAGE 20 OF 27
3.3.4.3
Command Name				Command Description
RebuildParity				Use this command to rebuild parity of an array which contains parity.
				i.e. RAID 5 or RAID 6.
Parameter 1				Parameter Description
Array No.:				Array No.:
<Array=<1~4>>				Specify an array number to rebuild parity.
Parameter 2				Status setting:
State setting:
<State=<Start:Stop>>				Start or stop the parity rebuilding of the specified array.
				Example
				CLI>RebuildParity Array=1 State=Start [Enter]
				Array 1 will start to rebuild parity if it exists and is configured as
				RAID 5 or RAID 6.
3.3.4.4
Command Name				Command Description
VerifyParity				Use this command to verify parity of an array which contains parity.
				i.e. RAID 5 or RAID 6
Parameter 1				Parameter Description
Array No.:				Array No.:
<Array=<1~4>>				Specify an array number to verify parity.
Parameter 2				Status setting:
State setting:
<State=<Start:Stop>>				Start or stop the parity verification of the specified array.
3.3.4.5
Command Name				Command Description
RefreshArray				Use this command to refresh data of the specified array.
Parameter 1				Parameter Description
Array No.:				Array No.:
<Array=<1~4>>				Specify an array number to be refreshed.
Parameter 2				State setting:
State setting:
<State=<Start:Stop:Pause>				Start, stop the array refreshment or just pause the refreshment and
>				restart it with ‘State=Start’ parameter any time after it has been paused.
				Example
				CLI>RefreshArray Array=1 State=Start[Enter]
				Array 1 will start to refresh data if it exists.