91

Are the fan power connectors properly connected to the server board?

Is the cable from the front panel board connected to the server board?

Are the power supply cables properly connected to the server board?

Are there any shorted wires caused by pinched cables or power connector plugs forced into power connector sockets the wrong way?

If the switches and connections are correct and AC power is available at the wall outlet, contact your service representative or authorized dealer for help.

Diskette Drive Activity Light Does Not Light

Check the following:

Are the diskette drive power and signal cables properly installed?

Are all relevant switches and jumpers on the diskette drive set correctly?

Is the diskette drive properly configured?

Is the diskette drive activity light always on? If so, the signal cable may be plugged in incorrectly.

If you are using the onboard diskette controller, use the Setup Utility to make sure that “Onboard Floppy” is set to “Enabled.” If you are using an add-in diskette controller, make sure that “Onboard Floppy” is set to “Disabled.”

If the problem persists, there may be a problem with the diskette drive, server board, or drive signal cable. Contact your service representative or authorized dealer for help.

CD-ROM Drive Activity Light Does Not Light

Check the following:

Are the power and signal cables to the CD-ROM drive properly installed?

Are all relevant switches and jumpers on the drive set correctly?

Is the drive properly configured?

Page 101
Image 101
Acer R700 manual Diskette Drive Activity Light Does Not Light, CD-ROM Drive Activity Light Does Not Light