Actiontec electronic Wireless-Ready

Configuring

the Gateway

Once the Gateway has been connected to a computer,it must be configured.Use

the following procedure.

1. If you connected the DSL Gateway correctly,a “Congratulations”window

appears.Click Next.

2. The first “Actiontec Installation Buddy”window appears.Read the instruc-

tions onscreen,select the type of ISP protocol,then click Next.(If you chose

“RFC 1483,”go to Step 4.)

Contents

Main Table of Contents Page Introduction Package Contents Minimum System Requirements Technical Support Connecting the Gateway Connecting the Power and DSL Cable Page Connecting to a Computer Page Connecting the Phone Filters Connecting Network Computers Page Page Page Page Page Page Using Qwest DSL Connecting to the Internet Disconnecting from the Internet Page Basic Setup Basic Setup Page Gateway Features Page Page Page Advanced Setup Accessing Advanced Setup WAN IPAddress Page Page Wireless Settings Page LAN IP Address DHCP Server Services Blocking Website Blocking VPN Pass Through Remote Management Port Forwarding DMZ Hosting MAC Address Cloning Status Page Utilities Web Activity Log DSL Settings Restore Default Settings Upgrade Firmware Page Page Troubleshooting Page Reference A Locating Computer Information Locating Windows Operating System Files Page Wiring Information Page Page Computer Security B Securing the Gateway and Computer Page Page Page Specifications C General Wireless Operating Range LED Indicators Environmental Page Glossary D Page Page Page Notices Regulatory Compliance Notices Modifications Page Limited Warranty