Adaptec ASA-7211C/F Removing the Red Hat Module

3-8

ASA-7211C/F Installation Guide

8To run the configure script, enter:

./configure

For Red Hat Linux 7.2, the following command works:

./configure --tree=/usr/src/linux-2.4.7-10

If the kernel source is not under /usr/src/linux-2.4.7-10, run the

configure script with the following option:

./configure --tree=<path to source tree>

9To copy the module to /lib/modules/<kernel version> and start the

module automatically on reboot, enter:

make install

10 To start the module now, enter:

./S06asa72xx

The module installation is complete. You do not need to reboot the

computer.

Removing the Red Hat Module

To remove the asa72xx module:

1Verify that no devices are being used by the adapter.

2Unmount all volumes from the adapter.

3If the asa72xx module is loaded, use rmmod or modprobe to

unload the module. Enter:

rmmod asa72xx

or enter:

modprobe -r asa72xx

4To change to the /usr/src/asa72xx directory, enter:

cd /usr/src/asa72xx

5To run the remove script, enter:

sh asa72xx_remove

6To remove the RPM, enter:

cd ..

and then enter:

rpm -e asa72xx

ASA-7211 IG.book Page 8 Tuesday, February 11, 2003 10:04 AM

Contents

Main INSTALLATION GUIDE Page iii Regulatory Compliance Statements Federal Communications Commission Radio Frequency Interference Statem ent European Union Compliance Statement Australian/New Zealand Compliance Statement iv Contents 1 Introduction 2 Installing the Adaptec iSCSI Adapter 3 Installing the Initiator Mode Driver Page Introduction Read This First Adaptec iSCSI Adapter Features Kit Contents Adapter Illustrations System Requirements Hardware Requirements Supported iSCSI targets Operating System Requirements Using the Adaptec iSCSI Installation CD About the Documentation Overview of the Installation Process Installing the Adaptec iSCSI Adapter Page Page Windows 2000 Installing the Driver in Windows2000 Updating the Driver in Windows2000 Page Windows NT 4.0 Installing the Driver in Windows NT 4.0 Updating the Driver in WindowsNT 4.0 Page Red Hat Linux Installing the Red Hat Module Removing the Red Hat Module Enabling Multi-LUN Support in Linux Page Configuring Your iSCSI System Running iConfig on Windows Running iConfig on Red Hat Linux Using Express Setup to Configure Your iSCSI Adapter 4-5 Configuring Your iSCSI System Changing Your iConfig Password For additional information, refer to the iConfig Utility Users Guide. Configuration Tasks A-1 A LEDs The following table describes the LED functionality for the ASA-7211C only. A-2 ASA-7211C/F Installation Guide The following table describes LED functionality for the ASA-7211F only.