Adaptec ASA-7211C/F The following table describes LED functionality for the ASA-7211F only.

1 33

The following table describes LED functionality for the ASA-7211F only.

Label on

Bracket1

1 See the appropriate figure on page 1-3.

Reference

Designator Function LED Description Color

1000 DS3 Rate

indictor

When lit, indicates a valid GbE

(1000Megabit/sec)

connection.

Green

ACT DS4 Activity

status When lit, indicates an incoming

signal or outgoing traffic. Yello w

ASA-7211 IG.book Page 2 Tuesday, February 11, 2003 10:04 AM

Contents

Main INSTALLATION GUIDE Page iii Regulatory Compliance Statements Federal Communications Commission Radio Frequency Interference Statem ent European Union Compliance Statement Australian/New Zealand Compliance Statement iv Contents 1 Introduction 2 Installing the Adaptec iSCSI Adapter 3 Installing the Initiator Mode Driver Page Introduction Read This First Adaptec iSCSI Adapter Features Kit Contents Adapter Illustrations System Requirements Hardware Requirements Supported iSCSI targets Operating System Requirements Using the Adaptec iSCSI Installation CD About the Documentation Overview of the Installation Process Installing the Adaptec iSCSI Adapter Page Page Windows 2000 Installing the Driver in Windows2000 Updating the Driver in Windows2000 Page Windows NT 4.0 Installing the Driver in Windows NT 4.0 Updating the Driver in WindowsNT 4.0 Page Red Hat Linux Installing the Red Hat Module Removing the Red Hat Module Enabling Multi-LUN Support in Linux Page Configuring Your iSCSI System Running iConfig on Windows Running iConfig on Red Hat Linux Using Express Setup to Configure Your iSCSI Adapter 4-5 Configuring Your iSCSI System Changing Your iConfig Password For additional information, refer to the iConfig Utility Users Guide. Configuration Tasks A-1 A LEDs The following table describes the LED functionality for the ASA-7211C only. A-2 ASA-7211C/F Installation Guide The following table describes LED functionality for the ASA-7211F only.