Adaptec ASA-7211C/F iii, Regulatory Compliance Statements

iiiRegulatory Compliance Statements

WARNING: Changes or modifications to this unit not expressly approved by the party

responsible for compliance could void the user’s authority to operate the equipment.

This equipment has been tested and found to comply with the limits for a ClassB digital device,

pursuant to Part15 of the FCC rules. These limits are designed to provide reasonable protection

against harmful interference in a residential installation. This equipment generates, uses, and

can radiate radio frequency energy, and if not installed and used in accordance with the

instruction manual, may cause harmful interference to radio communications. However, there is

no guarantee that interference will not occur in a particular installation. However, if this

equipment does cause interference to radio or television equipment reception, which can be

determined by turning the equipment off and on, the user is encouraged to try to correct the

interference by one or more of the following measures:

■Reorient or relocate the receiving antenna.

■Increase the separation between equipment and receiver.

■Connect the equipment to an outlet on a circuit different from that to which the receiver is

connected.

■Consult the dealer or an experienced radio/television technician for help.

■Use a shielded and properly grounded I/O cable and power cable to ensure compliance of

this unit to the specified limits of the rules.

This device complies with part15 of the FCC rules. Operation is subject to the following two

conditions: (1) this device may not cause harmful interference and (2) this device must accept

any interference received, including interference that may cause undesired operation.

This Information Technology Equipment has been tested and found to comply with

EMC Directive 89/336/EEC, as amended by 92/31/EEC and 93/68/EEC, in

accordance with:

■EN55022 (1998) Emissions

■EN55024 (1998) Immunity:

– EN61000-4-2 (1998) Electrostatic discharge: ±4 kV contact, ±8 kV air

– EN61000-4-3 (1998) Radiated immunity

– EN61000-4-4 (1995) Electrical fast transients/burst: ±1 kV AC, ±0.5 kV I/O

– EN61000-4-5 (1995) Surges ±1 kV differential mode, ±2 kV common mode

– EN61000-4-6 (1996) Conducted immunity: 3 V

– EN61000-4-11 (1994) Supply dips and variation: 30% and 100%

In addition, all equipment requiring U.L. listing has been found to comply with EMC

Directive 73/23/EEC as amended by 93/68/EEC in accordance with EN60950 with

amendments A1, A2, A3, A4, A11.

This device has been tested and found to comply with the limits for a Class B digital

device, pursuant to the Australian/New Zealand standard AS/NZS 3548 set out by

the Spectrum Management Agency.

Adaptec, Inc. ASA-7211C

Teste d to Co mp ly

With FCC Standards

FOR HOME OR OFFICE USE

ASA-7211F

ASA-7211 IG.book Page iii Tuesday, February 11, 2003 10:04 AM